Results 1 to 10 of about 45,467 (202)
Single-Phase Grounding Fault Types Identification Based on Multi-Feature Transformation and Fusion [PDF]
The frequent occurrence of single-phase grounding faults affects the reliable operation of power systems. When a single-phase grounding fault occurs, it is difficult to accurately identify the fault type because of the weak characterization and subtle ...
Min Fan, Jialu Xia, Xinyu Meng, Ke Zhang
doaj +4 more sources
Phase Selection Method for 10 kV Three-Core Cables Under Single-Phase Grounding Fault Transient Based on Surface Magnetic Field Sensing [PDF]
Single-phase grounding is the dominant fault type in urban power distribution networks. Because the total magnetic flux would not change around the cable under a single-phase grounding fault, ferromagnetic zero-sequence current sensors cannot distinguish
Hang Wang +6 more
doaj +2 more sources
Fault protection method of single-phase break for distribution network considering the influence of neutral grounding modes [PDF]
With the rapid development of modern distribution network and the access of distributed generation, the network structure is becoming increasingly complex.
Luo, Yongjie +4 more
core +4 more sources
Simulation Analysis of Single-phase Grounding Fault of Resonant Grounding System
For problem of difficult line selection caused by small current of fault line with uncertain direction when single-phase grounding fault happens in resonant grounding system, the paper theoretically analyzed change law of zero-sequence voltage and zero ...
LI Hui, TANG Yi, SUN Chang-qing
doaj +1 more source
There are some problems existing in the traditional grounding mode of the distribution network. To solve them, this paper proposes a flexible grounding method for neutral point.
Han Zeng +8 more
doaj +3 more sources
In order to use the existing hardware sources to improve the line selection performance of single-phase grounding fault of small resistance grounding systems, a method for line selection of single-phase grounding fault based on the global steady-state ...
LIU Jian +4 more
doaj +1 more source
Aiming at the problems that the existing arc suppression cabinet technology cannot adjust the zero sequence voltage flexibly and the control and hardware implementation of active arc suppression equipment based on power electronics are difficult, a new ...
Wu Lifang +7 more
doaj +1 more source
A single-end fault location method for single-phase nonmetallic grounding faults of transmission lines in a double terminal system is studied and proposed.
Botong Li +5 more
doaj +1 more source
To solve the problem of difficult location (especially high grounding resistances) for single‐phase grounding faults in distribution networks, a fault location method based on equivalent admittance distortion rate is proposed in this paper.
Yougen Chen +3 more
doaj +1 more source
In order to enhance effectiveness of single-phase ground fault feature extraction and to achieve exactly identification of fault line selection,a new fault line selection method of single phase grounding fault based on wavelet packet and online ...
JI Wen-lu +4 more
doaj +1 more source

