Results 21 to 30 of about 8,887,436 (231)
Feasibility analysis of neutral grounding by small reactor of HVDC converter transformer
Energy Reports, 2022 Nowadays, the scale of power grid is remarkably increasing and there is a continuous reinforcement of AC–DC hybrid systems. Thus, the single-phase grounding fault currents on the AC grid-side of rectifier and inverter stations increase significantly ...
Ensheng Zhao +5 more
doaj +1 more source
Modelling and control of current full compensation system‐based controllable voltage source
IET Generation, Transmission & Distribution, 2023 Current active suppression technology of arc overvoltage in distribution network has small capacity of controllable voltage source and complex control and cannot flexibly adjust the zero‐sequence voltage of neutral point.
Hongwen Liu +3 more
doaj +1 more source
One-mode component-based fault section location method for mine high-voltage power network
Gong-kuang zidonghua, 2021 After a single-phase grounding fault occurs in the mine high-voltage power network, it is important to identify the fault section quickly for the safe and stable operation of the mine power network.
ZHAO Jianwen, CHEN Jiali
doaj +1 more source
Single-phase grounding fault line selection method based on zero-sequence current increment
Energy Reports, 2022 To address single-phase grounding fault line selection problem in small current grounding distribution network, the paper proposes a fault line selection method based on zero-sequence current (ZSC) increment.
Bai Hao
doaj +1 more source
Design of a mine-used low-voltage leakage protection device
Gong-kuang zidonghua, 2020 In view of low reliability of leakage protection device of coal mine low-voltage power grid based on line selection principle of zero-sequence power direction, a hardware and software design scheme of mine-used low-voltage leakage protection device was ...
ZHENG Qingle +3 more
doaj +1 more source
Meikuang Anquan, 2022 When a single-phase grounding fault occurs in the coal mine 10 kV power supply system, due to the low sampling frequency of the system, the traditional transient line selection method is easy to lose the “line selection information”, and is greatly ...
GUO Runshou, CAO Jiyuan
doaj +1 more source
Vectorial Approach Based Control of a Seven-Phase Axial Flux Machine Designed for Fault Operation [PDF]
, 2008 Version éditeur disponible à l'adresse suivante : http://ieeexplore.ieee.org/stamp/stamp.jsp?tp=&arnumber=4519973&isnumber=4636792This paper deals with easy-to-implement control strategies when a seven-phase axial flux permanent magnet machine supplied ...
LOCMENT, Fabrice +5 more
core +2 more sources
, 2021 A single-end fault location method for single-phase nonmetallic grounding faults of transmission lines in a double terminal system is studied and proposed.
Jiang Su (9871913) +5 more
core +1 more source
The geometry and thickness of deformation-band fault core and its influence on sealing characteristics of deformation-band fault zones [PDF]
, 2005 Deformation-band faults in high-porosity reservoir sandstones commonly contain a fault core of intensely crushed rock surrounding the main slip surfaces.
Thompson, L.B. +2 more
core +8 more sources
, 2021 A single-end fault location method for single-phase nonmetallic grounding faults of transmission lines in a double terminal system is studied and proposed.
Jiang Su (9871913) +5 more
core +1 more source