Results 251 to 260 of about 45,125 (298)
Some of the next articles are maybe not open access.

A low-cost single-stage PV inverter

2018 IEEE Applied Power Electronics Conference and Exposition (APEC), 2018
This paper presents a low-cost single-stage PV inverter which integrates a front-end buck-boost converter and an output unfolding dc-ac inverter. It utilize only one main active switch (IGBT, MOSFET etc.) to regulate the output current and performs maximum power point tracking (MPPT) at the PV side. The buck-boost converter is operated in discontinuous
Yuxiang Shi   +3 more
openaire   +1 more source

An isolated single stage buck-boost inverter

2008 IEEE Power Electronics Specialists Conference, 2008
This paper presents a novel isolated single stage buck-boost inverter for implementing dc-to-ac, ac-to-dc or dc-to-dc. The BBI has better performances, in terms of low cost, high efficiency and high voltage gain. Through the HEV/EV application, the circuit operation principles and characteristics have been analyzed.
null Liang-hua Zhang   +2 more
openaire   +1 more source

High step-up single-stage boost inverter

2011 IEEE Energy Conversion Congress and Exposition, 2011
This paper presents a high step-up single-stage boost inverter. The basic topology is known in the literature as a Z-source inverter (ZSI). The ZSI has the ability of buck-boost conversion. No dead time is needed in phase legs, so high reliability can be achieved.
Yufei Zhou   +3 more
openaire   +1 more source

Single-Stage Boost Inverter With Coupled Inductor

IEEE Transactions on Power Electronics, 2012
Renewable power systems as distributed generation units often experience big changes in the inverter input voltage due to fluctuations of energy resources. Often, a front-end boost converter is added to step up the dc voltage when the energy resources are at a weak point.
Yufei Zhou, Wenxin Huang
openaire   +1 more source

A Single-Stage Square Wave Buck-Boost Inverter

Applied Mechanics and Materials, 2015
This paper proposed a novel single-stage square wave buck-boost inverter (SWBBI). The proposed inverter is designed by using dual buck-boost converters. The input DC voltage of the proposed inverter can be either stepped-down or stepped-up in square output voltage waveform depending on the duty-cycle applied for each buck-boost converter.
J.A. Soo, N.A. Rahman, J.H. Leong
openaire   +1 more source

A New Single Stage Quadratic Buck-Boost Inverter

2021 IEEE 12th International Symposium on Power Electronics for Distributed Generation Systems (PEDG), 2021
In this paper, a new single stage buck-boost inverter (BBI) called quadratic buck boost inverter (QBBI) was proposed for an enhanced voltage gain. The proposed inverter has merged the dc-dc converter stage and the dc-ac inverter stage into a single power stage.
Eltaib Abdeen D. Ibrahim   +3 more
openaire   +1 more source

PV-fed single phase single stage boost inverter

2012 International Conference on Computing, Electronics and Electrical Technologies (ICCEET), 2012
The aim of this paper is to model and simulate a boost inverter and its control method for implementing DC to AC power conversion method. The photovoltaic based load connected system depends up on the number of components and stages involved in the power conversion .The proposed scheme is applicable to any single -stage, single- phase grid connected ...
Anand.M Vijay, S.N Saritha.
openaire   +1 more source

A novel single stage inverter for MH lamps

2006 37th IEEE Power Electronics Specialists Conference, 2006
In this paper, a novel single stage inverter for metal halide (abbr. MH) lamps has been proposed, which integrates two power stages of DC/DC and DC/AC to one stage of DC/AC inverter. The main contributions as the following; (1) A new topologies for electronic ballast have been put forward and its principle has been investigated; (2) A controlling ...
Weiping Zhang   +3 more
openaire   +1 more source

A step-up/down single-stage ZVS inverter

IECON 2015 - 41st Annual Conference of the IEEE Industrial Electronics Society, 2015
In many applications such as power converters for fuel cells or distributed generating (DG) systems there is a need to increase the DC voltage before being inverted to AC grid or load with a higher voltage. The standard approach is to use a DC-DC converter to boost the input voltage followed by a buck inverter to converter the increased DC voltage into
Behnam Koushki   +3 more
openaire   +1 more source

A Novel Single-Stage Full-Bridge Buck-Boost Inverter

IEEE Transactions on Power Electronics, 2003
A novel single-stage full-bridge series-resonant buck-boost inverter (FB-SRBBI) is proposed in this paper. The proposed inverter only includes a full-bridge topology and a LC resonant tank without auxiliary switches. The output voltage of the proposed inverter can be larger or lower than the dc input voltage, depending on the instantaneous duty-cycle ...
openaire   +1 more source

Home - About - Disclaimer - Privacy