Results 11 to 20 of about 88,367,282 (284)
Fault Path Direct-Current Resistance Based Off-Line Single-Phase-To-Ground Fault Location
In order to figure out the off-line transmission line fault location, a new fault location method based on fault path direct current resistance measurement is proposed.
Fuzhi LI +6 more
doaj +2 more sources
The coal mine power supply and distribution system usually adopts the neutral point non-effectively grounded method. Most of the power supply lines in this method use cable lines.
SI Weibin +6 more
doaj +2 more sources
Incorporation of fault rock properties into production simulation models [PDF]
This thesis has two aims. First, to investigate the importance of incorporating the multiphase flow properties of faults into production simulation models.
Al-Busafi, Bader
core +7 more sources
The geometry and thickness of deformation-band fault core and its influence on sealing characteristics of deformation-band fault zones [PDF]
Deformation-band faults in high-porosity reservoir sandstones commonly contain a fault core of intensely crushed rock surrounding the main slip surfaces.
Thompson, L.B. +2 more
core +8 more sources
Fault-tolerant operation of single-phase SR generators [PDF]
This paper studies fault-tolerant operation of multipole single-phase switched reluctance generators (SRGs), in particular, an 8/8-pole switched reluctance machine.
Sawata, T. +9 more
core +3 more sources
Application of multiple resistive superconducting fault-current limiters for fast fault detection in highly interconnected distribution systems [PDF]
Superconducting fault-current limiters (SFCLs) offer several benefits for electrical distribution systems, especially with increasing distributed generation and the requirements for better network reliability and efficiency.
Burt, Graeme +3 more
core +4 more sources
Single-phase earth ground faults are the most frequent faults likely to occur but hard to identify in a distribution system, especially in a neutral ineffectively grounded system.
Su Xueneng +7 more
doaj +1 more source
The phase selection and fault location methods of generator stator winding single-phase grounding fault are greatly affected by the transition resistance.
Qinwei Li, Wenchao Jia
doaj +1 more source
Modelling and control of current full compensation system‐based controllable voltage source
Current active suppression technology of arc overvoltage in distribution network has small capacity of controllable voltage source and complex control and cannot flexibly adjust the zero‐sequence voltage of neutral point.
Hongwen Liu +3 more
doaj +1 more source
Methods in Single Phase to Ground Faults on Power Distribution Systems [PDF]
This study highlights the main contributions for the single phase to ground faults on distribution networks field throughout a last three decades from classic methods to heuristic methods. The surveys about 76 papers that are published in the field, the quantity of existing methods for each method is determined and categorized.
Soomro, Dur Muhammad +2 more
openaire +1 more source

