Results 131 to 140 of about 318,261 (306)
International Journal of Adaptive Control and Signal Processing, EarlyView.This paper proposes two projector‐based Hopfield neural network (HNN) estimators for online, constrained parameter estimation under time‐varying data, additive disturbances, and slowly drifting physical parameters. The first is a constraint‐aware HNN that enforces linear equalities and inequalities (via slack neurons) and continuously tracks the ...
Miguel Pedro Silva
wiley +1 more source
Integral Sliding Mode and Integral Supertwisting Sliding Mode Control for Ship Course-Keeping
IEEE AccessThis paper proposes variable structure-based nonlinear control algorithms, including synergetic, terminal synergetic, integral sliding mode, and integral supertwisting sliding mode controllers, for ship course-keeping.
Muhammad Munir Butt +2 more
doaj +1 more source
Current Tracking Adaptive Control of Brushless DC Motors
International Journal of Adaptive Control and Signal Processing, EarlyView.In this paper, the current tracking for Brushless Direct Current motors is approached considering uncertainty in the parameters of the motor's model. An adaptive control scheme to compensate electrical parameters uncertainty is proposed without requiring any knowledge of the mechanical parameters.
Fernanda Ramos‐García +3 more
wiley +1 more source
Bistable Mechanisms 3D Printing for Mechanically Programmable Vibration Control
Advanced Engineering Materials, EarlyView.This work introduces a 3D‐printed bistable mechanism integrated into tuned mass dampers (TMDs) for mechanically adaptive passive vibration suppression. Through optimized geometry, the bistable design provides adaptable vibration reduction across a broad range of scenarios, achieving effective vibration mitigation without complex controls or external ...
Ali Zolfagharian +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study reports the fabrication of trabecular bioactive glass scaffolds (composition “1d”: 46.1SiO2‐28.7CaO‐8.8MgO‐6.2P2O5‐5.7CaF2‐4.5Na2O wt%) through vat photopolymerization and the relevant results from mechanical testing and in vivo implantation procedures in rabbit femora, showing great promise for bone tissue engineering applications.
Dilshat Tulyaganov +8 more
wiley +1 more source
Effects of Carbon Nanoparticles on Triboelectro‐Induced Surface Defects
Advanced Engineering Materials, EarlyView.Carbon nanoparticles added to grease modify the electrocontact behavior. The synergy of particle concentration and electric current dominates the surface damage of metals in contact. Electrical surface damage caused by current leakage is a critical challenge in high‐performance applications such as electric vehicle (EV) drivetrains and wind turbine ...
Mohsen Tajedini +6 more
wiley +1 more source
Fixed-Time-Convergent Sliding Mode Control with Sliding Mode Observer for PMSM Speed Regulation
SensorsThis paper focuses on the speed control of a permanent magnet synchronous motor (PMSM) for electric drives with model uncertainties and external disturbances.
Xin Zhang, Hongwen Li, Meng Shao
doaj +1 more source
Can Ti‐Based MXenes Serve as Solid Lubricants for Brake Applications? A Tribological Study
Advanced Engineering Materials, EarlyView.This study explores the first implementation of Ti‐based MXenes materials in brake pad friction composite material. The resulting composite material exhibits a 48% reduction in the wear rate; alongside significant improvements are observed for thermal and mechanical properties.
Eslam Mahmoud +7 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source