Results 61 to 70 of about 3,177 (242)
Sulfide‐Based Electrolytes for All‐Solid‐State Sodium Batteries
This review covers the structural features and synthesis strategies of sulfide‐based solid electrolytes, as well as critical challenges related to conductivity, interfacial and moisture stability, and scaling‐up for practical application in Sodium‐based All Solid‐State Batteries.
Han Yang +6 more
wiley +1 more source
Microstructure and erosion-corrosion behaviour of as-cast high chromium white irons containing molybdenum in aqueous sulfuric-acid slurry was studied. The experimental irons contained 28 wt.%Cr with a Cr:C ratio of about 10 and up to 10 wt.%Mo. The irons
Imurai S. +3 more
doaj +1 more source
ABSTRACT This study investigates the rheological behavior of industrial phosphoric acids (H3PO4) produced at the JORF–LASFAR phosphoric plant in Morocco, with P2O5 concentrations of 18%, 29%, 42%, and 54%. Rheological measurements were performed using a rotary cylinder rheometer over a shear rate range of 1–1000 s−1.
Hamza Belbsir +6 more
wiley +1 more source
In this study, the potential of a Micro Slurry-jet Erosion (MSE) test to swiftly evaluate the intrinsic surface strength properties of thin multi-layer coatings is demonstrated.
Yoshiro Iwai +4 more
doaj +1 more source
Investigation of slurry erosion-corrosion behavior of Ta(Si1−xAlx)2 nanocrystalline coatings
To enhance the erosion-corrosion resistance of titanium alloys, two Ta(Si _1−x Al _x ) _2 coatings with different Al content were deposited on Ti−6Al−4V alloy by double cathode glow discharge method.
Jiang Xu +4 more
doaj +1 more source
Synthesis of trimethylolpropane trioleate by using stannous oxalate catalyst
Abstract This study was conducted to synthesize trimethylolpropane trioleate (TMPTO) using a stannous oxalate catalyst and investigate the dependence of the esterification rate on reaction variables. The highest esterification rate of approximately 99% was achieved at a 2.75:1 oleic acid/trimethylolpropane, 1.5% catalyst amount, 180°C reaction ...
Oguzhan Ilgen, Sumeyye Bilgic
wiley +1 more source
Evaluation of erosion of AISI 1045 carbon steel due to non-cohesive microparticles
Erosion behavior of AISI 1045 carbon steel was investigated using slurry solutions with different viscosities (1 cP, 3 cP, and 8 cP) containing 5 wt% silica sand as erodent particles.
Rehan Khan +4 more
doaj +1 more source
Improvement in Slurry Erosion and Corrosion Resistance of Plasma-Sprayed Fly Ash Coatings for Marine Applications. [PDF]
Chavana N, Bhajantri F V, Jambagi SC.
europepmc +1 more source
Cu‐Co Oxide/Carbon Composites Modified by DBD Plasma for Flexible Zn‐Air Battery Cathodes
A Cu3‐Co1/AC‐DBD composite catalyst was prepared using a “stepwise synthesis plasma synergistic modification” strategy, which exhibits excellent bifunctional catalytic activity. ABSTRACT This study is aimed at the demand for high‐performance energy storage systems in flexible wearable electronic devices, focusing on the development of cathode catalysts
Haixia Wu +8 more
wiley +1 more source
Precise regulation of radial sodium‐ion distribution, phase structure, and transition metal valence in P2/O3 composite cathodes without grain boundary significantly enhances resistance to an environment with high humidity and high concentration of CO2.
Minghuang Li +17 more
wiley +1 more source

