Results 31 to 40 of about 619,940 (356)
Review of solid-state linear transformer driver technology
Matter and Radiation at Extremes, 2018 This paper is a review of recent developments in solid-state linear transformer driver (SSLTD) for applications to pulsed power generation. It summarizes the technological advances reported by previous publications and interprets the experimental ...
Weihua Jiang
doaj +1 more source
Analysis and design of a modular multilevel converter with trapezoidal modulation for medium and high voltage DC-DC transformers [PDF]
, 2015 Conventional dual active bridge topologies provide galvanic isolation and soft-switching over a reasonable operating range without dedicated resonant circuits.
Adam, Grain P. +4 more
core +2 more sources
Review of Solid-State Transformer Applications on Electric Vehicle DC Ultra-Fast Charging Station
Energies, 2022 The emergence of DC fast chargers for electric vehicle batteries (EVBs) has prompted the design of ad-hoc microgrids (MGs), in which the use of a solid-state transformer (SST) instead of a low-frequency service transformer can increase the efficiency and
Seyedamin Valedsaravi +2 more
semanticscholar +1 more source
Design Proposal for a Compact, Solid-State, Low-Power Klystron-Pulser for CTF3 [PDF]
, 2001 A simple, compact, solid-state pulse generator using integrated gate commutated thyristors (IGCT's) is proposed for a low-power, pulsed L-band klystron system in the CLIC test facility CTF3 at CERN.
Pearce, P
core +1 more source
Energies, 2018 The winding is the core component of a transformer, and the technology used to diagnose its current state directly affects the operation and maintenance of the transformer.
Xiaomu Duan +4 more
doaj +1 more source
A single‐stage AC‐AC solid‐state transformer with ZVS operation
IET Power Electronics, 2021 Solid‐state transformer (SST) is an attractive concept, which provides galvanic isolation and voltage scaling by means of a medium‐frequency link.
Hui Wang +8 more
doaj +1 more source
Energies, 2021 Nowadays, the demand for high power converters for DC applications, such as renewable sources or ultra-fast chargers for electric vehicles, is constantly growing. Galvanic isolation is mandatory in most of these applications.
Alessandro La Ganga +2 more
doaj +1 more source
A novel miniature superconducting converter for 1 kA magnets [PDF]
, 1996 A miniature full-wave converter to control the current of a superconducting magnet is developed and tested in our institutes. Typical design values of the device are: AC voltage of 35 V, current of 7 A, and frequency 50-60 Hz; DC voltage o f f 0.2 V, and
Fedorovsky, Michael A. +3 more
core +3 more sources
Energy Management Strategy of AC/DC Hybrid Microgrid Based on Solid-State Transformer
IEEE Access, 2022 Voltage fluctuation and power mismatch which are caused by the decentralization, randomness, and intermittence of distributed energy resource along with load variability cause severe impacts on the security and quality of power network operation.
Zhengwei Qu +5 more
doaj +1 more source
Fully integrated CMOS power amplifier design using the distributed active-transformer architecture [PDF]
, 2002 A novel on-chip impedance matching and power-combining method, the distributed active transformer is presented. It combines several low-voltage push-pull amplifiers efficiently with their outputs in series to produce a larger output power while ...
Aoki, Ichiro +3 more
core +1 more source