Results 31 to 40 of about 7,429 (197)

A New Paradigm and Computational Framework to Estimate Stop-Signal Reaction Time Distributions from the inhibition of complex motor sequences

open access: yesFrontiers in Computational Neuroscience, 2015
Inhibitory control is an important component of executive function that allows organisms to abort emerging behavioral plans or ongoing actions on the fly as new sensory information becomes available.
Tobias eTeichert   +2 more
doaj   +1 more source

Multitarget high-definition transcranial direct current stimulation improves response inhibition more than single-target high-definition transcranial direct current stimulation in healthy participants

open access: yesFrontiers in Neuroscience, 2022
Prior studies have focused on single-target anodal transcranial direct current stimulation (tDCS) over the right inferior frontal gyrus (rIFG) or pre-supplementary motor area (pre-SMA) to improve response inhibition in healthy individuals.
Zhihua Guo   +6 more
doaj   +1 more source

Electrochemical Noise for Detection of Stress Corrosion Cracking of Low Carbon Steel Exposed to Synthetic Soil Solution [PDF]

open access: yesMaterials Research, 2017
In the last years, electrochemical noise (EN) has demonstrate that is capable of detect the initiation of cracks during the slow strain rate tests (SSRT).
Antonio Contreras   +3 more
doaj   +2 more sources

Study on the Corrosion Resistance of 39SiCrVTiA High strength and high toughness spring steel [PDF]

open access: yesMATEC Web of Conferences, 2021
39SiCrVTiA spring steel is heat-treated and compared with the existing high-strength spring steels 60Si2CrVA and SAE9254 for electrochemical impedance spectroscopy (EIS), polarization curve and slow strain rate testing (SSRT).
Nie Lun   +4 more
doaj   +1 more source

Investigation of Stress Corrosion Cracking Behaviour of Mg-Al-Zn Alloys in Different pH Environments by SSRT Method

open access: yesOpen Chemistry, 2019
In this study, stress corrosion behaviors of AZ31, AZ61 and AZ91 Mg alloys which contain different amounts of Al were investigated under acidic, basic and neutral environments having chloride ions using Slow Strain Rate Test (SSRT) method.
Catar Recep, Altun Hikmet
doaj   +1 more source

Measurement and Reliability of Response Inhibition

open access: yesFrontiers in Psychology, 2012
Response inhibition plays a critical role in adaptive functioning and can be assessed with the Stop-signal task, which requires participants to suppress prepotent motor responses.
Eliza eCongdon   +6 more
doaj   +1 more source

Modeling and Numerical Validation of Stress-Strain Curves of Maraging Steels, Grades 300 and 350 Under Hydrogen Embrittlement [PDF]

open access: yesMaterials Research, 2021
Maraging steels are ferrous alloys with Ni, Co, Mo, and Ti additions. These materials are a special class of ultra high mechanical strength steels with wide and special applications in strategic areas, which makes their knowledge very valuable ...
R. Chales   +5 more
doaj   +1 more source

Alcohol affects neuronal substrates of response inhibition but not of perceptual processing of stimuli signalling a stop response [PDF]

open access: yes, 2013
Alcohol impairs inhibitory control, including the ability to terminate an initiated action. While there is increasing knowledge about neural mechanisms involved in response inhibition, the level at which alcohol impairs such mechanisms remains poorly ...
A Green   +78 more
core   +1 more source

Hydrogen Stress Cracking Behaviour in Dissimilar Welded Joints of Duplex Stainless Steel and Carbon Steel

open access: yesMetals, 2021
As the need for duplex stainless steel (DSS) increases, it is necessary to evaluate hydrogen stress cracking (HSC) in dissimilar welded joints (WJs) of DSS and carbon steel.
Hanji Park   +3 more
doaj   +1 more source

Corrosion Behavior of Pure Titanium by MIM Process under SSRT Condition

open access: yesJournal of the Japan Society of Powder and Powder Metallurgy, 2007
There exist difficulties in preparing pure titanium or titanium alloys by the ingot metallurgy (I/M) because of their poor machinability. Recently, powder metallurgy (P/M) has been applied to produce the titanium products since it has the advantage of better formability.
Satoshi Sunada   +2 more
openaire   +2 more sources

Home - About - Disclaimer - Privacy