Results 191 to 200 of about 57,703,494 (237)

Programming Actuation in 3D‐Printed Micro‐Architectures via Interfacial Adhesion Control

open access: yesAdvanced Materials Technologies, EarlyView.
A two‐phase meniscus‐guided 3D printing method directly fabricates microscale poly(3,4‐ethylenedioxythiophene) polystyrene sulfonate (PEDOT:PSS) and poly(vinyl alcohol) (PVA) bilayers with in situ programmable interfaces. Modulating the meniscus stretching speed switches the interface between separated and bonded states, which controls the mechanical ...
Xiao Huan   +13 more
wiley   +1 more source

3D‐Printed Actuator Powered by Liquid Crystal Elastomer Muscles at the Water–Air Interface

open access: yesAdvanced Materials Technologies, EarlyView.
Soft robots for unstructured environments require responsive, durable actuators. Liquid crystal elastomers (LCEs) provide large reversible deformations under thermal or optical stimuli. Direct ink writing enables fabrication of LCE actuators integrated with silicone, with mesogen chemistry and oligomers optimized for printable inks.
Cecilie Ryberg   +5 more
wiley   +1 more source

High‐Density Magnetomyography With Optical Magnetometers Reveals Spatiotemporal Patterns of Evoked Muscle Activity

open access: yesAdvanced Materials Technologies, EarlyView.
Optically pumped magnetometers are employed to contactlessly map the spatiotemporal dynamics of the magnetic field linked to electrical activity of a skeletal muscle in vivo. It is demonstrated that localization of the clinically relevant innervation zone is feasible using this non‐invasive magnetic measurement modality. ABSTRACT Magnetomyography (MMG)
Simon Nordenström   +12 more
wiley   +1 more source

In vitro renal artery stenting using a steerable guide wire navigated by a mobile electromagnetic field. [PDF]

open access: yesJ Vasc Surg Cases Innov Tech
Zielasek C   +5 more
europepmc   +1 more source

Extrusion‐Based Bioprinting of Living Bioinks for Tissue and Organ Engineering

open access: yesAdvanced Materials Technologies, EarlyView.
Extrusion‐based bioprinting is presented as the most versatile route for fabricating living, heterogeneous tissues. Its ability to combine diverse bioinks, support matrices, and advanced printhead geometries transforms familiar constraints into powerful biofabrication opportunities.
Eric Silberman   +4 more
wiley   +1 more source

Contact‐Architecture‐Dependent Mixed Ionic‐Electronic Transport in Solution‐Grown MAPbBr3 Microwire Photodetectors

open access: yesAdvanced Optical Materials, EarlyView.
MAPbBr3 microwire photodetectors reveal a strong architecture dependence of mixed ionic–electronic phototransport. A single‐gap device exhibits pronounced illumination‐history‐dependent transients governed by trap‐assisted injection and ionic polarization, whereas a multi‐gap configuration averages local interfacial effects and yields stable ...
Sebastiano De Stefano   +16 more
wiley   +1 more source

Early experience with the SmartGUIDE: A new generation of in-situ deflectable 0.014-inch guidewire. [PDF]

open access: yesInterv Neuroradiol
Al-Tibi M   +9 more
europepmc   +1 more source

Home - About - Disclaimer - Privacy