Results 1 to 10 of about 22,115 (289)
The influence of textiles on Corona discharge created around a human fingertip [PDF]
, 2007 A corona discharge is a visible, electrical discharge observed in gases, which occurs on the surface of charged conductors. In our research, the discharges were generated around human fingertips and recorded in the form of films during the test while a ...
Ciesielska-Wrobel, Izabela +1 more
core
AUTEX Research Journal, 2020 This paper aims to provide rapid and precise methods to allow industrials to predict the amount of sewing thread needed to sew a garment using different lockstitches of class 300 (301, 301/301, 304, 308, 309, 310, 311, 312, and 315).
Sarah Malek +3 more
doaj +1 more source
Investigation of experimental research on the low velocity impact damage behavior of ncf composite plates – COMPLAS XII [PDF]
, 2013 In this study an experimental investigation is performed on the impact response of non-crimp fabric composite plates at room temperature. Chopped strand mat combi is used as reinforcing material and two kinds of matrix; epoxy and polyester, are also used
Agir, I., Bektas, N. B., Kursun, A.
core
Control of a single-particle localization in open quantum systems
, 2017 We investigate the possibility to control localization properties of the asymptotic state of an open quantum system with a tunable synthetic dissipation.
Denisov, S. +4 more
core +1 more source
Dimensional Characteristics of Knitted Fabrics Made from 100% Cotton and Cotton/Elastane Yarns
Journal of Engineering, 2018 The dimensional characteristics such as loop length (l), wales per centimeter (wpc), courses per centimeter (cpc), stitch density (s), tightness factor (K), loop shape factor (R) and take-up rate (T) of single jersey, 1x1rib, 1x1 interlock, single pique,
Dereje Berihun Sitotaw
doaj +1 more source
Acoustic Properties of Multi-Layer Wool Nonwoven Structures
Journal of Natural Fibers, 2020 Wool insulating materials provide good acoustic insulation and are increasingly used for room insulation. These insulating materials are usually produced using nonwoven techniques.
Jan Broda, Marcin Bączek
doaj +1 more source
Influence of stitching parameters on the tensile performance and failure mechanisms of CFRP T-joints
e-PolymersT-joints made from carbon fiber reinforced polymer (CFRP) composites are widely used in aircraft fuselages. However, CFRP structures are prone to interlaminar delamination, for which stitching reinforcement presents a promising solution.
Jin Xin +7 more
doaj +1 more source
Mehran University Research Journal of Engineering and TechnologyUsing the 100% polyethylene Terephthalate (PET) 75/72 DTY semi-intermingle yarn, three different weft-knitted structures are manufactured on similar gauge circular weft knitting machines.
Muhammad Owais Raza Siddiqui +4 more
doaj +1 more source
Analysis of Shape Nonconformity between Embroidered Element and Its Digital Image
Medžiagotyra, 2014 Embroidery technologies are widely applied for developing decorative elements of original design in garments, for integrating threads intended for protection into garments and other articles.
Svetlana RADAVIČIENĖ +6 more
doaj +1 more source
Knowledge Graph Completion to Predict Polypharmacy Side Effects
, 2018 The polypharmacy side effect prediction problem considers cases in which two drugs taken individually do not result in a particular side effect; however, when the two drugs are taken in combination, the side effect manifests. In this work, we demonstrate
AM Manicone +10 more
core +1 more source