Results 101 to 110 of about 1,454,667 (331)

The Role of Calcitonin Gene‐Related Peptide in High‐Altitude Headache: A Prospective Field Study

open access: yesAnnals of Clinical and Translational Neurology, EarlyView.
ABSTRACT Objective High‐altitude headache (HAH) is a common neurological condition associated with rapid ascent to high altitude. The pathophysiological mechanisms underlying HAH remain incompletely understood. Calcitonin gene‐related peptide (CGRP), a neuropeptide implicated in migraine pathophysiology, may play a key role in the pathophysiology of ...
Roman Schniepp   +4 more
wiley   +1 more source

Comparison of Selected Methods of Stress Measurements in Ferromagnetic Materials

open access: yesEngineering Transactions, 2015
Change in magnetisation of a ferromagnetic subjected to mechanical stress is known as Vilarie's effect. The paper describes contactless measurement of stress based on this effect.
Z.H. Żurek
doaj   +1 more source

A Systematic Comparison of Alpha‐Synuclein Seed Amplification Assays for Increasing Reproducibility

open access: yesAnnals of Clinical and Translational Neurology, EarlyView.
ABSTRACT Seed amplification assays (SAAs) enable ultrasensitive detection of misfolded α‐synuclein across biofluids and tissues. Yet, heterogeneity in protocols limits cross‐study comparability and clinical translation. Here, we review α‐synuclein SAA methods and their performance across various biological matrices.
Manuela Amaral‐do‐Nascimento   +3 more
wiley   +1 more source

Influenza Vaccination Responses in Disabled Stroke Patients: A Single‐Center Prospective Observational Study

open access: yesAnnals of Clinical and Translational Neurology, EarlyView.
ABSTRACT Objective This study aimed to investigate the immunological response to influenza vaccination, the incidence and severity of influenza infection, and the side effects of the vaccination in patients with ischemic stroke. Methods This prospective observational study was conducted between 2023 and 2024 at Ramathibodi Hospital.
Achiraya Pakngao   +5 more
wiley   +1 more source

Direct Strain and Stress Measurement for Prestressed Steel. [PDF]

open access: yes, 2000
Bridge assessment requires knowledge of the design prestress and of any losses that may occur since stressing. The knowledge on state of stress in prestressing wires of prestressed beams is a very important criteria when assessment is conducted on an ...
Isaak, Suhaila
core  

Artificial Intelligence in Systemic Sclerosis: Clinical Applications, Challenges, and Future Directions

open access: yesArthritis Care &Research, EarlyView.
Systemic sclerosis (SSc) is a rare autoimmune disease defined by immune dysregulation, vasculopathy, and progressive fibrosis of the skin and internal organs. Despite advances in care, major complications such as interstitial lung disease (ILD) and myocardial involvement remain the leading causes of morbidity and mortality.
Cristiana Sieiro Santos   +2 more
wiley   +1 more source

Experimental X-ray Stress Analysis Procedures for Ultra High Strength Materials [PDF]

open access: yes
X-ray stress analysis procedures for accurate measurement of elastic strain in high strength ...
Barkley, W. J., III   +4 more
core   +1 more source

Uporaba abrazivnog vodenog mlaza za mjerenje zaostalih naprezanja u željezničkim kotačima [PDF]

open access: yes, 2012
The paper provides a general introduction to methods of measurement of residual stresses on railway wheels. Determination of residual stress distribution is necessary for the prediction of wheel service life and possible catastrophic failure.
Brumek, Jan   +2 more
core  

Characterization of Defect Distribution in an Additively Manufactured AlSi10Mg as a Function of Processing Parameters and Correlations with Extreme Value Statistics

open access: yesAdvanced Engineering Materials, EarlyView.
Predicting extreme defects in additive manufacturing remains a key challenge limiting its structural reliability. This study proposes a statistical framework that integrates Extreme Value Theory with advanced process indicators to explore defect–process relationships and improve the estimation of critical defect sizes. The approach provides a basis for
Muhammad Muteeb Butt   +8 more
wiley   +1 more source

Experimental Evaluation of 100Cr6 Steel Microindented Surfaces Under Lubricated Nonconformal Point Contacts

open access: yesAdvanced Engineering Materials, EarlyView.
The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi   +3 more
wiley   +1 more source

Home - About - Disclaimer - Privacy