Implementation of the mechanistic wall boiling model in IC engine cooling gallery simulation
MATEC Web of Conferences, 2018 The ever increasing power rates of modern IC engines pose a great challenge for maintaining the optimal temperature conditions. The current trend in the thermal management of IC engines is to utilize the limited and controlled nucleate boiling to achieve
Abyzov Oleg +2 more
doaj +1 more source
Journal of Thermal Science and Technology, 2013 For predicting the void fraction distribution in subcooled flow boiling, it is necessary to measure the interfacial heat transfer coefficient—which determines the amount of condensation rate of vapor bubble—with high accuracy.
Noriaki INABA +2 more
doaj +1 more source
Subcooled freon-11 flow boiling in top-heated finned coolant channels with and without a twisted tape [PDF]
An experimental study was conducted in top-heated finned horizontal tubes to study the effect of enhancement devices on flow boiling heat transfer in coolant channels.
Boyd, Ronald D., Sr., Smith, Alvin
core +1 more source
Effect of surfactant on flow boiling heat transfer of ethylene glycol/water mixtures in a mini-tube [PDF]
, 2014 This paper was presented at the 4th Micro and Nano Flows Conference (MNF2014), which was held at University College, London, UK. The conference was organised by Brunel University and supported by the Italian Union of Thermofluiddynamics, IPEM, the ...
4th Micro and Nano Flows Conference (MNF2014) +4 more
core
Coupled heat and mass transfer simulation of CRUD migration and deposition in PWR systems
Nuclear Engineering and TechnologyIn Pressurized Water Reactors (PWRs), corrosion products are released during operation due to the large contact area between the primary circuit coolant and the equipment materials.
Xuesong Li +5 more
doaj +1 more source
Analytical and experimental study of boiler instabilities due to feed-system - Subcooled region coupling [PDF]
Instabilities occurring in forced-flow, electrically heated, downflow boiler due to feed system-subcooled region ...
Grace, T. M., Krejsa, E. A.
core +1 more source
Similarities and differences between flow boiling in microchannels and pool boiling [PDF]
, 2009 This paper was presented at the 2nd Micro and Nano Flows Conference (MNF2009), which was held at Brunel University, West London, UK. The conference was organised by Brunel University and supported by the Institution of Mechanical Engineers, IPEM, the ...
2nd Micro and Nano Flows Conference (MNF2009) +1 more
core
Gravity independent subcooled flow boiling heat transfer regime
Experimental Thermal and Fluid Science, 2004 Abstract Using an existing model for vapor bubble detachment, a subcooled flow boiling regime was identified where vapor bubble dynamics are independent of the gravitational field. The Jakob number and a dimensionless flow parameter were used to identify the boundaries of this regime.
Department of Mechanical and Aerospace Engineering, University of Florida, Gainesville, FL 32611-0510, USA ( host institution ) +2 more
openaire +2 more sources
Design sensitivity analysis of a plate-finned air-cooled condenser for waste heat recovery ORCs [PDF]
, 2015 The study is related to the design sensitivity analysis of a plate-finned tube bundle V-shaped air-cooled condenser design problem for a range of representative low-temperature waste heat recovery Organic Rankine Cycle (ORC) cases.
De Paepe, Michel +2 more
core +1 more source
Subcooled boiling incipience on a highly smooth microheater
International Journal of Heat and Mass Transfer, 2006 Abstract Subcooled boiling incipience on a highly smooth microscale heater (270 μm × 270 μm) submerged in FC-72 liquid is investigated. Using high-speed imaging and a transient heat flux measurement technique, the mechanics of homogeneous nucleation on the heater are elucidated.
Chen, Tailian +3 more
openaire +5 more sources