Results 121 to 130 of about 412 (167)

Film boiling of subcooled liquids. Part II: Steady regimes of subcooled liquids film boiling

International Journal of Heat and Mass Transfer, 2016
Abstract As it was shown in the first part of the present study [1], during film boiling of highly subcooled water the particular regime of boiling occurred revealed first in the works [2,3], where the term “micro-bubble boiling” was introduced for this regime.
V.V. Yagov, M.A. Leksin, A.R. Zabirov, M.A. Denisov   +3 more
openaire   +1 more source

Boiling of subcooled liquid

2007
The description of the forced convection boiling of subcooled liquid started with using the equilibrium thermodynamics of two-phase flow.
openaire   +1 more source

Subcooled Boiling Heat Transfer

1994
Abstract After a brief comment concerning heat transfer to a single-phase liquid flowing in a channel, the remainder of this chapter is taken up with the topic of heat transfer to a flowing subcooled liquid under conditions where nucleate boiling takes place at the channel wall.
John G Collie, F R S F Eng, R John, Thome D Phil   +3 more
openaire   +1 more source

Critical Heat Flux in Subcooled Flow Boiling

Proceeding of International Heat Transfer Conference 11, 1998
This chapter reports a survey of recent experimental work performed to obtain parametric trends of critical heat flux (CHF) in water-subcooled flow boiling, with special concern for high liquid velocity and subcooling, small-diameter channels, and low-intermediate pressure, together with a review of current modeling analysis.
openaire   +1 more source

EFFECT OF LIQUID SUBCOOLING ON BOILING SOUND IN SUBCOOLED POOL BOILING

Proceeding of International Heat Transfer Conference 17, 2023
Noriyuki Unno, Kazuhisa Yuki, Shin-ichi Satake, Koichi Suzuki   +3 more
openaire   +1 more source

Void Fractions in Subcooled Flow Boiling

Journal of Heat Transfer, 1969
A semianalytic model is presented for the prediction of void fractions in subcooled flow boiling at elevated pressures. The model is based on the formation and growth of a bubble boundary layer adjacent to the heated surface at a rate determined by the difference between the imposed surface heat transfer and the heat removal capability of the subcooled
P. S. Larsen, L. S. Tong
openaire   +1 more source

The influence of flow development on subcooled boiling

International Communications in Heat and Mass Transfer, 1990
Abstract The effect of flow development on the onset of subcooled boiling has been analyzed. It has been found that the onset of subcooled boiling is suppressed near the inlet of the channel where the flow is not thermally developed. The well-known Saha-Zuber model for the onset of subcooled boiling has been modified to accommodate flows near the ...
A. Clausse, R.T. Lahey
openaire   +1 more source

A CFD Modeling of Subcooled Pool Boiling

2018
Subcooled pool boiling is of immense importance in many industrial and engineering systems because of its great heat transfer coefficient in comparison with other heat transfer mechanisms. However it is one of the most complicated two-phase phenomena due to, for example, the simultaneous liquid/vapor motion at the same time with heat and mass transfer ...
T. T. Nguyen, H. N. Duong, V. T. Tran, H. Kikura   +3 more
openaire   +1 more source

Boiling curve correlation for subcooled flow boiling

International Journal of Heat and Mass Transfer, 1995
Ronald D. Boyd, Xiaowei Meng
openaire   +1 more source

HEAT TRANSFER DURING SUBCOOLED BOILING

1963
Abstract : (1) Average heat transfer coefficients on a uniformly heated cylinder. Experimental data were presented for a Reynolds number range from 40 to 100,000 and for Prandtl numbers from 1 to 300. The effects of temperature differences large enough to produce significant changes in viscosity across the boundary layer were correlated in terms of a ...
openaire   +1 more source