Results 41 to 50 of about 676 (179)
Exploring the potential of Textile Reinforced Concrete for corrosion‐insensitive retaining walls
Abstract In a context where durability concerns, particularly the corrosion of steel reinforcement, remain a critical challenge for conventional reinforced concrete structures under severe exposure, Textile Reinforced Concrete (TRC) is emerging as a promising alternative.
J. Devènes +3 more
wiley +1 more source
Strong‐yet‐ductile precipitation‐hardening alloys require novel microstructural complexity of precipitates in particularly at cryogenic condition, to constantly impart strain hardening of hard‐and‐brittle precipitates. The present work creates innovative structurally complex precipitates assembled with dispersed nanocores and a chemical‐heterogeneity ...
Shaohua Gao +9 more
wiley +1 more source
Hot Deformation Behavior of 2507 Super Duplex Stainless Steel
The hot compression test of 12 mm hot rolled sheet of 2507 super duplex stainless steel (/% : 0. 022C, 0. 58Si, 25. 35Cr, 7. 17Ni, 4. 05Mo, 0. 28N) with strain rate 0. 01 ~ 10 s-1at 1 000 〜1 150 °C has been carried out by using MMS-200 thermal-mechanical
王佳夫 +4 more
doaj
This study validates a recycling pathway for converting interconnect assemblies from end‐of‐life SOC stacks into commercial‐grade AISI 304 steels. Using scrap‐based steelmaking operations, austenitic cast steels with <4.0% δ‐ferrite are successfully produced.
Jeraldine Lastam +7 more
wiley +1 more source
Distribution and Characteristics of Residual Stresses in Super Duplex Stainless Steel Pipe Weld
This paper explores the distribution and features of residual stresses formed by super duplex stainless steel pipe welding. Experimental investigations, which encompass an elevated temperature tensile test and metallographic observation along with a ...
Chang Beck Cho +2 more
doaj +1 more source
Heat treatments that alter the proportions of austenite and ferrite phases or induce the precipitation of phases such as sigma in duplex stainless steel UNS S32205 make it more susceptible to pitting and crevice corrosion. However, the effects of these treatments are not always evident when analyzed using the cyclic polarization technique.
Alba Regina Turin +8 more
wiley +1 more source
ABSTRACT Machining of materials is an invaluable technique to give specific shapes and dimensions of desired materials. Different machining processes give rise to different surface characteristics that include not only surface roughness but also specific surface morphology, such as the recast layer.
Animesh Kumar Basak +4 more
wiley +1 more source
Analysis on Composition, Properties and Precipitated Phases of Duplex Stainless Steel
The composition, corrosion resistance and application of normal and super duplex stainless steels have been summarized, and different kinds of precipitated phases, harmful phases, pitting resistant equivalent (PRE) and effect of welding on structure and ...
于海成 +4 more
doaj
Laser welding of duplex stainless steel disrupts phase balance, promotes nitride precipitation, and reduces fatigue resistance. Postweld heat treatment restores austenite and dissolves nitrides, but the resulting crystallography and phase morphology still impair fatigue performance.
Aparecida Silva Magalhães +6 more
wiley +1 more source
ABSTRACT This study investigates the impact of hydrogen soaking on the medium‐cycle fatigue behavior of various metallic materials commonly used in gas transmission pipelines. The tested materials include ex‐service gray cast iron, ex‐service X52 carbon steel, brass, and welded X52 carbon steel.
E. Kufoin +7 more
wiley +1 more source

