Results 61 to 70 of about 1,209,985 (213)
, 2022 11th European Stainless Steel Conference - Science & Market & 7th European Duplex Stainless Steel Conference ...
franceschi mattia, dabala, yazdanpanah
core
steel research international, Volume 97, Issue 9, Page 4483-4493, September 2026.An accurate moving boundary model for volume diffusion containing boundary conditions from trans‐interface diffusion (TID) simulates the austenite growth during cooling. TID of Cr, Mo, N and Ni enhance growth kinetics. Without TID, compositions of the interface region change, decreasing the driving force for growth and finally causing numerical ...
A. Salwén +3 more
wiley +1 more source
Advanced Science, Volume 13, Issue 46, 17 August 2026.Strong‐yet‐ductile precipitation‐hardening alloys require novel microstructural complexity of precipitates in particularly at cryogenic condition, to constantly impart strain hardening of hard‐and‐brittle precipitates. The present work creates innovative structurally complex precipitates assembled with dispersed nanocores and a chemical‐heterogeneity ...
Shaohua Gao +9 more
wiley +1 more source
steel research international, Volume 97, Issue 8, Page 4363-4381, August 2026.This study validates a recycling pathway for converting interconnect assemblies from end‐of‐life SOC stacks into commercial‐grade AISI 304 steels. Using scrap‐based steelmaking operations, austenitic cast steels with <4.0% δ‐ferrite are successfully produced.
Jeraldine Lastam +7 more
wiley +1 more source
Structural Concrete, Volume 27, Issue 4, Page 6271-6295, August 2026.Abstract With the market introduction of new reinforcing materials, such as corrosion‐resistant steel, the effect of their stress–strain relationship on the ductility of reinforced concrete structures needs to be evaluated. Their moment‐curvature behavior significantly influences bending moment redistributions, rotation capacity, and deformation at ...
Nathalie Reckinger +2 more
wiley +1 more source
Field Exposure of Duplex Stainless Steel in the Marine Environment: The Impact of the Exposure Zone
Corrosion and Materials DegradationOwing to its corrosion resistance, stainless steel is a sustainable alternative to carbon steel as a structural material in challenging seawater environments. Studies on carbon steel indicate that among all marine corrosion zones (i.e., atmospheric zone,
Saman Hosseinpour +3 more
doaj +1 more source
Teshugang, 2021 The microstructure of 00Cr29Ni6Mo2N super duplex stainless steel solution-treaded at 1080 ℃ for 30 min + aged at 650 ~ 1000 °C for 60 min is investigated by means of scanning electron microscopy (SEM) and energydispersive X-ray spectrometer (EDS).
苗华军
doaj
Lubricants, 2018 A lean duplex stainless steel, LDX2404, was DC plasma nitrided under a range of treatment conditions. The microstructure characterisation evaluation of the treated samples revealed that a dense, super-hard surface layer can be produced by low-temperature
Xiaoying Li +3 more
doaj +1 more source
Influence of Friction Stir Processing on Mechanical Behavior of 2507 SDSS
Metals, 2020 Duplex stainless steel (DSS) is used for desalination equipment, pressure vessels, marine applications, offshore applications, and in oil/gas plants where a highly corrosive environment is present.
Hafiz M. Abubaker +4 more
doaj +1 more source
steel research international, Volume 97, Issue 7, Page 3456-3473, July 2026.Heat treatments that alter the proportions of austenite and ferrite phases or induce the precipitation of phases such as sigma in duplex stainless steel UNS S32205 make it more susceptible to pitting and crevice corrosion. However, the effects of these treatments are not always evident when analyzed using the cyclic polarization technique.
Alba Regina Turin +8 more
wiley +1 more source