Results 101 to 110 of about 9,504,346 (343)

Comparative Effectiveness and Safety of Inebilizumab Versus Rituximab in AQP4‐IgG‐Positive NMOSD

Annals of Clinical and Translational Neurology, EarlyView.
ABSTRACT Objective Rituximab (anti‐CD20, RTX) and inebilizumab (anti‐CD19, INE) represent B‐cell‐depleting therapies used for aquaporin‐4 antibody‐positive (AQP4‐IgG+) neuromyelitis optica spectrum disorder (NMOSD); however, direct comparative evidence remains limited.
Jie Lin, Binbin Xue, Dewei Xie, Jia Li, Juyuan Pan, Lanbing Zhu, Qiaowen Tong, Jing Lin, Ruofan Zhu, Xu Zhang, Junhui Xia, Xiang Li   +11 more
wiley   +1 more source

Cracking the Code: Which Ocular Symptoms Predict Dry Eye Signs? Insights from a large international sicca registry

Arthritis Care &Research, Accepted Article.
Purpose The study aimed to identify symptom‐based predictors of dry eye disease (DED) signs in the Sjögrens International Collaborative Clinical Alliance (SICCA) cohort. Methods Retrospective analysis examining 16 ocular symptoms (most graded 0‐4) and artificial tear (AT) use (graded 0‐3) as predictors of DED signs [abnormal ocular surface staining ...
Pragnya R Donthineni, Chloe Shields, Rohit Muralidhar, Shreya Bhatt, Alan Baer, Robert Fox, Sara S. McCoy, Anat Galor   +7 more
wiley   +1 more source

Effects of sand ripples on the wave-induced seabed instability of the surface seabed

Applied Ocean Research
Wave-induced seabed instability significantly impacts the hydrodynamics of flow-particle interaction near the seabed surface. Previous studies on seabed instability mostly assume a flat seabed, neglecting the influence of sand ripple morphology on wave ...
Titi Sui, Zhendi Yang, Song Gao, Favour Boadi Narh, Yunhan Yang, Musheng Yang   +5 more
doaj   +1 more source

Slope-controlled surface instabilities

Philosophical Magazine Letters, 2004
Stochastic Monte Carlo simulations have been used to reproduce recent experimental studies of nanoisland growth on silicon surfaces. In the presence of a Schwoebel barrier the surface shows two different phases (flat areas in coexistence with tall mounds), in agreement with experimental results.
openaire   +1 more source

Electrochemical Evaluation of Compressed Selective Laser Melted AlSi7Mg and AlSi10Mg Alloys in Chloride Environment

Advanced Engineering Materials, EarlyView.
The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin, Samson Dare Oguntuyi, Peter Apata Olubambi   +2 more
wiley   +1 more source

Prediction of Surface Topography Parameters in Direct Laser Interference Patterning of Stainless Steel Using Infrared Monitoring and Convolutional Neural Networks

Advanced Engineering Materials, EarlyView.
This study presents an infrared monitoring approach for direct laser interference patterning (DLIP) combined with a convolutional neural network (CNN). Thermal emission data captured during structuring are used to predict surface topography parameters.
Lukas Olawsky, Marcelo Sallese, Leander Kläber, Clemens Kuhn, Keming Du, Andrés Fabián Lasagni   +5 more
wiley   +1 more source

Microstructural Evolution and Vacancy Defect Formation in Mn–Mo–Ni RPV Steel Under Low Cycle Fatigue: Insights From EBSD and PALS

Advanced Engineering Materials, EarlyView.
Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar, Dhanadeep Dutta, G. Bharat Reddy   +2 more
wiley   +1 more source

Stability of mud-water interface under long surface waves

AIP Advances, 2019
Fluid mud often exists in coastal areas with an interface separating it from its upper water layer. When a surface wave propagates over a bed covered with water and fluid mud, it will cause an interfacial wave of the mud-water interface, which damps the ...
Jiebin Liu, Jifu Zhou
doaj   +1 more source

Thermodynamic Pathways of Nonequilibrium Solidification in Wire‐Arc Additive Manufacturing Fe‐Based Multicomponent Alloy Structures

Advanced Engineering Materials, EarlyView.
Geometry‐driven thermal behavior in wire‐arc additive manufacturing (WAAM) influences microstructural evolution during nonequilibrium solidification of a chemically complex Fe–Cr–Nb–W–Mo–C nanocomposite system. By comparing different deposits configurations, distinct entropy–cooling rate correlations, segregation, and carbide evolution are revealed ...
Blanca Palacios, Anthony Gonzalez, Aleksander Aleman, Tyler Dolmetsch, Tanaji Paul, Arvind Agarwal   +5 more
wiley   +1 more source

Deformation characteristics of overlying strata in room and pillar mined-out areas under coal pillar instability

Scientific Reports
Under the condition of small roof deformation before the occurrence of fractures and collapse in room and pillar mined-out areas caused by coal pillar instability, the surface deformation may be large, which threatens the safety of ground structures ...
Yaming Liu, Tianfeng Gu, Yanchao Wang, Wei Xiong, Xuanyu Yang   +4 more
doaj   +1 more source