Results 11 to 20 of about 22,416,474 (360)
Surface Potential Driven Water Harvesting from Fog. [PDF]
ACS Nano, 2021 Access to clean water is a global challenge, and fog collectors are a promising solution. Polycarbonate (PC) fibers have been used in fog collectors but with limited efficiency. In this study, we show that controlling voltage polarity and humidity during
Ura DP +8 more
europepmc +2 more sources
Estimation of the surface potential of clay mineral taking Na+/K+-specific ion effects into account
Frontiers in Materials, 2022 Surface potential is a key electrochemical property of colloids in the study of particle interactions. However, the specific ion effects are not involved in the existing measuring methods.
Xiaodan Gao +4 more
doaj +1 more source
Journal of Advanced Dielectrics, 2023 The characterization of pyroelectric materials is essential for the design of pyroelectric-based devices. Pyroelectric current measurement is the commonly employed method, but can be complex and requires surface electrodes.
Reinhard Schwödiauer +4 more
doaj +1 more source
Biosurface and Biotribology, 2022 It is challenging to match the mutual interactions between implant and host because the biomaterials usually cannot actively adjust their performance to the changing microenvironment.
Haisheng Qi +7 more
doaj +1 more source
Potential energy surfaces for gas-surface reactions [PDF]
Physical Chemistry Chemical Physics, 2011 A method for constructing the potential energy surface for reactions of a molecule with the surface of cleaved non-conducting crystals is reported. The method uses systematic fragmentation to express the total potential in terms of potential energy surfaces which describe reactions of relatively small molecules in the gas phase.
Frankcombe, Terry, Collins, Michael
openaire +3 more sources
Mapping the Electronic Surface Potential of Nanostructured Surfaces [PDF]
Physical Review Letters, 2009 We present a method for the quantitative determination of the surface potential landscape of nanostructured surfaces based on the local analysis of the lowest field emission resonances by scanning tunneling spectroscopy. The method has a lateral resolution of approximately 1 nm and is applied to elucidate the site-specific adsorption properties of the ...
Ruffieux P +6 more
openaire +3 more sources
Materials & Design (1980-2015), 2020 Surface potential of biomaterials is a key factor regulating cell responses, driving their adhesion and signaling in tissue regeneration. In this study we compared the surface and zeta potential of smooth and porous electrospun polycaprolactone (PCL ...
Sara Metwally +13 more
semanticscholar +1 more source
Surface tensions and surface potentials of acid solutions [PDF]
The Journal of Chemical Physics, 2010 A theory is presented which allows us to quantitatively calculate the excess surface tension of acid solutions. The H+, in the form of hydronium ion, is found to be strongly adsorbed to the solution-air interface. To account for the electrostatic potential difference measured experimentally, it is necessary to assume that the hydronium ion is oriented ...
Santos, Alexandre P. dos, Levin, Yan
openaire +3 more sources
Investigation on the Hump Behavior of Gate-Normal Nanowire Tunnel Field-Effect Transistors (NWTFETs)
Applied Sciences, 2020 The hump behavior of gate-normal nanowire tunnel field-effect transistors (NWTFETs) is investigated by using a three-dimensional technology computer-aided design (TCAD) simulation.
Min Woo Kang, Woo Young Choi
doaj +1 more source
Journal of Engineering Technology and Applied Physics, 2022 Although, dynamic power in portable mobile devices can be reduced by reducing power supply VDDon the cost of increased leakage current. Therefore, maintaining low leakage current in the device is serious issue for minimizing overall ...
Tan Chun Fui +2 more
doaj +1 more source