Results 21 to 30 of about 450,396 (139)

From transmission error measurement to Pulley-Belt slip determination in serpentine belt drives : influence of tensioner and belt characteristics [PDF]

open access: yes, 2009
Serpentine belt drives are often used in front end accessory drive of automotive engine. The accessories resistant torques are getting higher within new technological innovations as stater-alternator, and belt transmissions are always asked for higher ...
Dufour, Regis   +7 more
core   +1 more source

Dynamics of suspended sediment transport and yield in a large agricultural catchment, southwest France [PDF]

open access: yes, 2010
The dynamics of suspended sediment transport were monitored continuously in a large agricultural catchment in southwest France from January 2007 to March 2009.
Simeoni-Sauvage, Sabine   +6 more
core   +1 more source

In situ observation of warm atmospheric layer and the heat contribution of suspended dust over the Tarim Basin [PDF]

open access: yesAtmospheric Chemistry and Physics, 2022
Based on radiosonde observations from the spring and summer of 2016–2017, we verified the existence of an anomalously warm atmospheric layer and quantified the heat contribution of suspended dust over the Tarim Basin (TB) in northwest China.
C. Zhou   +21 more
doaj   +1 more source

Belt and suspender technique for bipolar bone loss in shoulder instability

open access: yesJSES Reviews, Reports, and Techniques, 2022
Bipolar glenohumeral bone loss is a challenging condition to address in patients with recurrent anterior shoulder instability. In this category of patients, most isolated soft-tissue procedures such as remplissage or infraspinatus capsulotenodesis are associated with high risk of failure and instability recurrence. Even bony procedures such as Latarjet
Johnny Abboud   +4 more
openaire   +4 more sources

A novel framework for turbidity source apportionment of the urban lakeside river network

open access: yesEcological Indicators, 2023
Turbidity source apportionment is essential but complex for precise environmental rehabilitation of worldwide urban lakeside river networks impaired by turbidity.
Renhua Yan   +3 more
doaj   +1 more source

Elite Military Belts of the 8th – 9th Centuries from the Stavropol State Museum Reserve Funds

open access: yesВестник Волгоградского государственного университета. Серия 4. История, регионоведение, международные отношения, 2020
Introduction. The article is devoted to the typological and chronological analysis of the details of three prestigious belt sets stored in the funds of the G.N. Prozritelev and G.K.
Yury A. Prokopenko   +1 more
doaj   +1 more source

MODAL ANALYSIS OF A BRIDGE FRAME FOR BELT CONVEYORS [PDF]

open access: yesAnnals of the University of Petroşani. Mechanical Engineering, 2023
This paper is devoted to the modal analysis of a 3D bridge frame subjected to the weight of the materials to be moved during full-capacity transport, where the moving belt rests on suspended hanging roller sets from beams installed mounted in the middle ...
Sandor Szirbik, Zoltan Virag
doaj  

Contemporary suspended sediment yield of Caucasus mountains [PDF]

open access: yesProceedings of the International Association of Hydrological Sciences, 2019
Processes linked to climate change and intensified anthropogenic pressure influence the environment, the hydrology and by extent the denudation processes in the Caucasus mountain belt.
A. Tsyplenkov   +4 more
doaj   +1 more source

Hysteretic behavior of a belt tensioner: modeling and experimental investigation [PDF]

open access: yes, 2005
In this paper we describe the modeling of the hysteretic behavior of belt tensioners. An initial experimental device is composed only of the tensioner by using forcing frequencies, preloads and deflection amplitudes.
Dufour, Regis   +2 more
core   +1 more source

Belt separation system under slat in fattening pig housing: Effect of belt type and extraction frequency [PDF]

open access: yes, 2010
The efficiency of manure separation by a conveyor belt under a partially slatted floor for fattening pigs was determined for two types of belts, a flat belt with an incline of up to 6° transversely and a concave belt with an incline of up to 1 ...
Ovejero Rubio, Ismael   +5 more
core   +1 more source

Home - About - Disclaimer - Privacy