On vortex/wave interactions. Part 2. Originating from axisymmetric flow with swirl [PDF]
, 2006 Following the study in Part 1 of cross-flow and other non-symmetric effects on vortex/wave interactions in boundary layers, the present Part 2 applies the ideas of Part 1 and related works to an incident axisymmetric flow supplemented by a small swirl or
Allen, T, Brown, SN, Smith, FT
core +1 more source
3D Numerical Simulation and Performance Analysis of CO2 Vortex Tubes
Applied Sciences, 2021 In view of the extensive application of swirl flow pipes (vortex tubes) in refrigeration systems, the parameters of swirl flow pipes were investigated to provide optimal cooling and heating conditions. Three-dimensional numerical simulations were carried
Qijun Xu, Jinfeng Wang, Jing Xie
doaj +1 more source
The Planetary Science Journal, 2023 The spectrophotometric properties of two study areas in the Ingenii swirl region show that the combined effects of multiple processes are required to explain the regolith’s mineralogical and physical properties.
Deborah Domingue +7 more
doaj +1 more source
Whirls and swirls of polarization [PDF]
Science, 2021 Exotic toroidal polarization textures in a polymer ferroelectric interact with terahertz ...
openaire +4 more sources
Effects of Swirl Flow on Spray Characteristics in a Swirl-Stabilized Combustor
Journal of Fluid Science and Technology, 2008 This paper presents experimental data on the characteristics of a kerosene spray flame produced by a hollow-cone pressure-atomized nozzle in a swirl-stabilized combustor.
Mohammad GHAFFARPOUR, Alireza NOORPOOR
doaj +1 more source
The Effect of Inlet Swirl on the Rotordynamic Shroud Forces in a Centrifugal Pump [PDF]
, 1992 The role played by fluid forces in determining the rotordynamic stability of a centrifugal pump is gaining increasing attention. The present research investigates the contributions to the rotordynamic forces from the discharge-to-suction leakage flows ...
Acosta, A. J. +3 more
core +2 more sources
Anisotropy analysis of turbulent swirl flow [PDF]
FME Transactions, 2014 Anisotropy invariant map proposed by Lumley and Newman and barycentric map proposed by Banerjee et al. were used in order to estimate the degree of anisotropy in turbulent swirl flow.
Radenković Darko R. +2 more
doaj
A method of processing mechanical mixtures using vortex set of deep separation [PDF]
Омский научный вестник, 2018 There is described a new method of processing mechanical mixtures using a vortex set of deep separation – VCGS and experimental model of a new vortex separator in the form of cyclone nozzles.
V. I. Kuznetsov, O. A. Sharikov
doaj +1 more source
Vortex method of complex purification from mechanical pollution by impurities of surface and bottom layers of water bodies with use of vortex separators (separators-confusers, cyclones-confusers) [PDF]
Омский научный вестник: Серия "Авиационно-ракетное и энергетическое машиностроение", 2018 The method of purification from mechanical pollution by oil, oil products, other materials of surface and bottom surfaces of water bodies with the use of vortex equipment: swirlers, vortex tubes, separatorsconfusers, cyclones is described-confusors, as ...
V. I. Kuznetsov, O. A. Sharikov
doaj +1 more source
Design of a Swirl-Stabilized Burner With Fluidically Variable Swirl Number
Volume 3B: Combustion, Fuels, and Emissions, 2023 Abstract For flame stabilization, burner systems are usually equipped with swirlers which incite a defined air rotation, quantified by the swirl number. In consequence, the swirl number, which significantly influences the flame dynamics, is fixed.
Eck, Mattias E. G. +4 more
openaire +2 more sources