Results 121 to 130 of about 328,138 (300)

Harnessing ambient sound: Different approaches to acoustic energy harvesting using triboelectric nanogenerators

Journal of Science: Advanced Materials and Devices
As a sustainable energy source, sound is abundant in the environment, but its effective conversion into electrical energy remains a technical challenge.
Fandi Jean, Muhammad Umair Khan, Anas Alazzam, Baker Mohammad   +3 more
doaj   +1 more source

Cognitive Status in People With Epilepsy in the Republic of Guinea: A Prospective, Case–Control Study

Annals of Clinical and Translational Neurology, EarlyView.
ABSTRACT Objective People with epilepsy (PWE) may experience cognitive deficits but fail to undergo formal evaluation. This study compares cognitive status between PWE and healthy controls in the West African Republic of Guinea. Methods A cross‐sectional, case–control study was conducted in sequential recruitment phases (July 2024–July 2025) at Ignace ...
Maya L. Mastick, Cheick O. Soumah, Malé Doré, Oumar Mara, Desiré Neldje, Fodé A. Cissé, Toure M. Lamine, Aminata Diallo, Seungwon Lee, Siddharth Satish, Alexander J. X. Chen, Alice Liu, Nomin Enkhtsetseg, Farrah J. Mateen, The Guinea Epilepsy Project   +14 more
wiley   +1 more source

SymPET, a waveform digitizing "System on Chip" for ultra-high resolution TOF PET: design concept and preliminary studies. [PDF]

IEEE Nucl Sci Symp Conf Rec (1997), 2022
Flood K, Chock C, Blackberg L, Feng Y, Hashemi S, Macchiarulo L, Mishra M, Thelen D, Mostafanezhad I, Sabet H.   +9 more
europepmc   +1 more source

Experimental Evaluation of 100Cr6 Steel Microindented Surfaces Under Lubricated Nonconformal Point Contacts

Advanced Engineering Materials, EarlyView.
The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi, Pasquale Guglielmi, Gianfranco Palumbo, Giuseppe Carbone   +3 more
wiley   +1 more source

System on Chip (SoC) for Invisible Electrocardiography (ECG) Biometrics. [PDF]

Sensors (Basel), 2022
de Melo F, Neto HC, da Silva HP.
europepmc   +1 more source

Planar Solid‐State Nanopores Toward Scalable Nanofluidic Integration Based on CMOS Technology

Advanced Engineering Materials, EarlyView.
We present a scalable silicon‐based fabrication strategy for planar solid‐state nanopores to enable their integration with complex nanofluidic systems. Prototype devices demonstrate normal voltage‐current characteristics, good noise performance, and appreciable streaming currents. Our CMOS‐compatible fabrication process offers precise geometric control
Ngan Hoang Pham, Chenyu Wen, Mohammad Hadi Khaksaran, Won‐Yong Lee, Javier Cruz, Klas Hjort, Dongping Wu, Shi‐Li Zhang   +7 more
wiley   +1 more source

Flexible Data Rate Allocation Using Non-Orthogonal Multiple Access (NOMA) in a Mode Division Multiplexing (MDM) Optical Power Splitter for System-on-Chip Networks. [PDF]

Sensors (Basel), 2023
Lin YZ, Chow CW, Yu TW, Jian YH, Hung TY, Chen JW, Yeh CH.   +6 more
europepmc   +1 more source

Innovative Processing of Compacted Waste Aluminum Alloy Powders via Controlled Remelting and Solidification

Advanced Engineering Materials, EarlyView.
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira, Marcella Gaute Cavalcante Xavier, Abdoul‐Aziz Bogno, Piter Gargarella, José Eduardo Spinelli   +4 more
wiley   +1 more source

A Lightweight System-On-Chip Based Cryptographic Core for Low-Cost Devices. [PDF]

Sensors (Basel), 2022
Gookyi DAN, Ryoo K.
europepmc   +1 more source

Prediction of Surface Topography Parameters in Direct Laser Interference Patterning of Stainless Steel Using Infrared Monitoring and Convolutional Neural Networks

Advanced Engineering Materials, EarlyView.
This study presents an infrared monitoring approach for direct laser interference patterning (DLIP) combined with a convolutional neural network (CNN). Thermal emission data captured during structuring are used to predict surface topography parameters.
Lukas Olawsky, Marcelo Sallese, Leander Kläber, Clemens Kuhn, Keming Du, Andrés Fabián Lasagni   +5 more
wiley   +1 more source