Results 1 to 10 of about 82,701 (138)
Mechanical Engineering Journal, 2014 Thermal fatigue cracking may initiate at a T-junction pipe where high and low temperature fluids mix. In this study, wall temperature characteristics at a T-junction pipe were investigated to improve the evaluation method for thermal fatigue.
Koji MIYOSHI +3 more
doaj +4 more sources
Drag Reduction of T-junction Pipe Flow by Small Obstacles
Journal of Fluid Science and Technology, 2011 Flows in the T-junction of a counter-flow pipe are run counter to each other and they usually flow out vertically together. A flow separated from the junction corner forms separated vortex regions and they reduce the effective cross-sectional areas of ...
Toshitake ANDO +3 more
doaj +4 more sources
Conjugate numerical simulation of wall temperature fluctuation at a T-junction pipe
Mechanical Engineering Journal, 2018 Thermal fatigue cracks may occur in a T-junction pipe due to the mixing of hot and cold fluids. To develop an evaluation method for thermal fatigue, the authors previously performed a mixing tee experiment called the T-Cubic experiment.
Yoichi UTANOHARA +2 more
doaj +4 more sources
Effects of flow rate ratio on loss reduction of T-junction pipe
Journal of Fluid Science and Technology, 2014 T-junction pipes are frequently used in industrial facilities to split one flow into two flows or to merge two flows into one flow. In the counter-flow type of confluence in this type of pipe, separated vortex flow regions are formed near the junction ...
Toshitake ANDO +3 more
doaj +4 more sources
Mechanical Engineering Journal, 2014 Thermal fatigue cracking may initiate at a T-junction pipe where high and low temperature fluids flow in from different directions and mix. Thermal stress is caused by a temperature gradient in a structure and by its variation.
Koji MIYOSHI +2 more
doaj +4 more sources
Non-Isothermal Vortex Flow in the T-Junction Pipe
Energies, 2021 The numerical simulation approach of heat carrier mixing regimes in the T-junction shows that the RANS approach is beneficial for a qualitative flow analysis to obtain relatively agreed averaged velocity and temperature. Moreover, traditionally, the RANS
Tatyana A. Baranova +4 more
doaj +2 more sources
Multi-Gait In-Pipe Locomotion via Programmable Friction Reorientation [PDF]
BiomimeticsIn-pipe robots must navigate narrow, curved passages where rigid mechanisms often require bulky steering units. Soft crawlers offer better compliance but typically rely on multiple actuators or reconfigurable contacts to achieve multi-directional motion.
Jaehyun Lee, Jongwoo Kim
doaj +2 more sources
Force Analysis of a Circular Cylinder at Ununiformed Flow in a T Pipe Junction
Energies, 2018 Experimental and numerical investigations of force analysis acted on single circular cylinder in the T pipe junction with the effect of vanes are reported in this paper. Experiments are carried on in a small wind tunnel at five different velocity ratios (
Yantao Yin +4 more
doaj +3 more sources
Geometric parameters optimization of low resistance T-junction with guide vanes in HVAC system [PDF]
E3S Web of Conferences, 2022 In recent years, with the increasing energy consumption and carbon emissions, people are paying more and more attention to related measures for energy conservation and emission reduction.
Yin Yifei +3 more
doaj +1 more source
Numerical Simulation Analysis of Different Flow Directions in T-Junction [PDF]
Cailiao Baohu, 2021 During the process of using the pipe, the leakage of the pipe perforation was caused by the erosion and wear of the micro solid particles in the pipe medium.Thus, DPM erosion prediction model in Fluent software was used to conduct numerical simulation of
YAN Hong-wei, WANG Lu, PENG Fang-xian, LI Peng-cheng, YANG Xiong, HOU Xiang-rong
doaj +1 more source