Results 11 to 20 of about 10,843,040 (254)
A study of unsteady flow wave attenuation in partially filled pipe networks [PDF]
, 1984 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.The attenuation of unsteady flow in building drainage systems must be fully considered if water conservation proposals involving changes in flush volume or
Bridge, Sarah
core +7 more sources
A Worm-Inspired Origami Robot with Multimodal Locomotion for Adaptive Mobility in Complex Pipeline Environments. [PDF]
Adv Sci (Weinh)An origami worm‐inspired robot achieves multimodal locomotion in confined pipelines through mechatronic integration that embeds actuation, control, and communication within each origami module. Large, reversible configuration and dimensional changes enable 25 gaits synthesized by a unified framework across peristaltic, inchworm, and wheel‐rolling modes
Zhang Q +6 more
europepmc +2 more sources
B016: Water Pipe Junction Block
, 2006 Local Name: GüzelbeyliLocal Informant: Ismail DönertaşLatitude: 37.42.35.01Longitude: 28.40.08.76Elevation: 446mDimensions: not measuredDescription: Found in an Ottoman graveyard (B015).
Aphrodisias Regional Survey
core +7 more sources
Substrate Engineering of SWCNT p-n Junctions for Dual-Mode Power Generation and Heat-Flux Sensing. [PDF]
Adv Sci (Weinh)Through substrate engineering alone, a single‐walled carbon nanotube p–n junction device switches between two functions under uniform infrared irradiation. A low‐absorbance substrate sustains a central hot junction for continuous power generation, whereas high‐absorbance substrates transiently invert the temperature gradient for sensitive heat‐flux ...
Tamai R +3 more
europepmc +2 more sources
International Journal of Emerging Trends in Engineering Research, 2023 Thermal fatigue is a material deterioration caused by temperature. Thermal fatigue or commonly referred to as Thermal Fatigue is a potential risk in the piping system, it can occur in the mixing flow at the T-junction.
semanticscholar +1 more source
A case study of thermal mixing behavior of hot and cold fluid in T-junction with/without mixing jets
Case Studies in Thermal Engineering, 2023 Three-dimensional numerical simulations are performed to study the turbulent mixing of hot and cold fluids at a T-junction with unique branch pipe extended mixing jets.
Sandeep Rimza +3 more
doaj +1 more source
Estimation method of pipe wall thinning tendency at T tube in actual plant
Nihon Kikai Gakkai ronbunshu, 2023 Flow-Accelerated Corrosion (FAC) is a pipe wall thinning phenomenon to be monitored and managed in the power plants with high priority. Its management has been conducted with conservative evaluation of thinning rate and residual lifetime of piping based ...
Shun WATANABE +2 more
doaj +1 more source
, 2021 This record was harvested from a previous catalogue system and will be withdrawn in 2025. Information in this record may be superseded or incomplete.
Reinforced Concrete and Monier Pipe Construction Co. Pty Ltd
core +7 more sources
Frontiers in Energy Research, 2020 The T-junction has been extensively employed in nuclear power plant systems. To ensure the normal operation of nuclear power plant, the onset point of T-junction liquid entrainment requires in-depth studies.
Xiaoyu Li +6 more
doaj +1 more source
Actuators, 2016 This paper proposes a magnetic actuator using multiple vibration components to perform locomotion in a complex pipe with a 25 mm inner diameter. Due to the desire to increase the turning moment in a T-junction pipe, two vibration components were attached
Hiroyuki Yaguchi +2 more
doaj +1 more source