Results 51 to 60 of about 2,624,502 (199)
Strength and High-Temperature Stability of Dispersion Strengthened Nickel-MgO Alloys [PDF]
Strength and high-temperature stability of dispersion strengthened nickel-magnesium oxide ...
Quatinetz, M. +3 more
core +1 more source
Hydroxypropyl cellulose (HPC) is a non-digestible water-soluble polysaccharide used in various food, cosmetic, and pharmaceutical applications. In the current study, the aqueous solutions of six HPC grades, with molecular mass ranging from 40 to 870 kDa,
Diana Cholakova +5 more
doaj +1 more source
We theoretically demonstrate the formation of multiple bi-stability regions in the temperature pattern on the interface between a cuprous oxide quantum well and DCM2:CA:PS organic compound.
Agranovich +15 more
core +1 more source
Temperature stability in the sub-milliHertz band with LISA Pathfinder [PDF]
This article has been accepted for publication in "Monthly notices of the royal astronomical society" published by Oxford University Press.LISA Pathfinder (LPF) was a technology pioneering mission designed to test key technologies required for ...
Armano, M. +6 more
core +2 more sources
A Plasmonic Fiber Based Glucometer and Its Temperature Dependence
We present the plasmonic fiber based optical glucometer. A thin gold layer is coated on clad-free core of multimode optical fiber along 3 cm length to excite surface plasmons at 632.8 nm wavelength. Glucose oxidase is immobilized on the metal surface for
Jisoo Kim +4 more
doaj +1 more source
Structural and electrical properties of CuAlMo thin films prepared by magnetron sputtering [PDF]
The structural and electrical properties of a low resistivity CuAlMo thin film resistor material were investigated. The thin films were grown on Al2O3 and glass substrates by direct current (dc) magnetron sputtering.
Bashev +31 more
core +1 more source
Stability of heating temperature on cytotoxicity
Chinese hamster V79 cells were used to test the cytotoxic effect of heat which alternates between high and low temperatures during the treatment period. This type of temperature fluctuation is often encountered in clinical hyperthermia. Two sets of heating protocols were used in the experiments: Temperature alternates (a) between 42 and 43 degrees and (
P S, Lin, A, Wu, K C, Ho
openaire +2 more sources
Electrostatically-Driven Resonator on Soi with Improved Temperature Stability [PDF]
This paper deals with a single-crystal-silicon (SCS) MEMS resonator with improved temperature stability. While simulations have shown that the temperature coefficient of resonant frequency can be down to 1 ppm/degrees C, preliminary measurements on non ...
Bosseboeuf, A. +4 more
core +2 more sources
Power-Temperature Stability and Safety Analysis for Multiprocessor Systems
Modern multiprocessor system-on-chips (SoCs) integrate multiple heterogeneous cores to achieve high energy efficiency. The power consumption of each core contributes to an increase in the temperature across the chip floorplan. In turn, higher temperature
Bhat, Ganapati +2 more
core +1 more source
Temperature Stability of Piezoelectric Ceramics [PDF]
This paper reports an investigation into the fundamental temperature stability of piezoelectric ceramics through thermal aging and thermal shock tests. The dependence of piezoelectricity on thermal aging and thermal shock of low Q m and high Q m materials was clarified. The surface charges generated by the thermal
Toshio Ogawa, Kikuo Wakino
openaire +1 more source

