Results 1 to 10 of about 2,879,726 (341)
Miniaturized differential scanning calorimeter with an integrated mass sensing system: first steps [PDF]
Journal of Sensors and Sensor Systems, 2023 In this paper, the first steps towards integrating a mass sensing system into an existing miniaturized ceramic DSC (differential scanning calorimetry) chip are presented.
J. Distler +7 more
doaj +1 more source
Gauge to simultaneously determine the electrical conductivity, the Hall constant, and the Seebeck coefficient up to 800 °C [PDF]
Journal of Sensors and Sensor Systems, 2023 A new high temperature gauge to simultaneously determine the electrical conductivity, the Hall constant, and the Seebeck coefficient has been developed. Screen-printed heating structures on a ceramic sample holder are used to generate temperatures up to ...
R. Werner +4 more
doaj +1 more source
Novel, low-cost device to simultaneously measure the electrical conductivity and the Hall coefficient from room temperature up to 600 °C [PDF]
Journal of Sensors and Sensor Systems, 2021 A novel measurement device for simultaneous high temperature measurements of the electrical conductivity and the Hall coefficient has been developed.
R. Werner +4 more
doaj +1 more source
Chemical Physics Impact, 2023 Green synthesized Silver nanoparticles (AgNP) have attracted the most attention among others as it is an efficient antibacterial agent with low toxicity, environmentally beneficial and commercially viable. Since the attributes of AgNP are size-dependent,
Delma Jones Rufina R +2 more
doaj +1 more source
Assessment of residential settlement planning in Medina, based on climate adaptability [PDF]
E3S Web of Conferences, 2023 The theme of World Habitat Day 2020 was Housing for All: “A Better Urban Future”. In light of this postulate, this study aims to determine the climate response of traditional urban morphology to the Sousse climate, which allows us to assess the ...
Benzarti ep Ghedas Habiba +2 more
doaj +1 more source
Molecules, 2021 Cryogels are novel materials because the manufacturing process known as cryostructuring allows biopolymers to change their properties as a result of repeated controlled freeze–thaw cycles.
Jonathan Coria-Hernández +3 more
doaj +1 more source
Structural characterization of Huadian oil shale kerogen by using 13C DP/MAS NMR [PDF]
Oil Shale, 2021 Quantitative 13C direct polarization/magic angle spinning (DP/MAS) solid-state nuclear magnetic resonance (SSNMR) was used to characterize type I kerogen isolated from Huadian oil shale.
Xiaoye Wang +5 more
doaj +1 more source
Thermal Analysis of Fin: Comparative Thermal Analysis
International Journal For Multidisciplinary Research, 2023 The fins are extended surfaces that are made to increase the rate of heat transfer through the equipment/components. Generally, they are used for faster cooling of the equipment/components. The comparative thermal analysis of rectangular fin and porous fin is done in the paper. Both the fins are subjected to the same conditions i.e., both the fins have
Mrunmayee Kulkarni - +3 more
openaire +1 more source
Capture of CO2 by vermiculite impregnated with CaO
Carbon Management, 2022 Vermiculite samples were impregnated with different amounts of calcium oxide by the conventional thermal heating technique and subject to CO2 capture experiments in thermal analysis equipment. The amount of CO2 captured by calcium oxide increased from 13
Matheus Henrique Simplício Pereira +4 more
doaj +1 more source
Materials Research Letters, 2023 The yield strength of the [001]-orientated single-crystal nickel-based superalloy PWA1483 is investigated under tension/compression at 1000 and 1100 °C. We found that the compressive yield strength is larger than the tensile strength.
P. Zhang +6 more
doaj +1 more source