Results 51 to 60 of about 32,584 (261)
Advanced Engineering Materials, EarlyView.Solvate ionic liquids lubrication reduced the coefficient of friction by ∼60% compared to dry sliding, reaching steady‐state values as low as 0.04–0.05. Corrosion weight‐loss measurements in 1 M HCl further demonstrated significant inhibition behavior, with only 100 ppm of [Li(G3)][TFSI] (∼68.5 μL/L) reducing corrosion‐product weight loss by 63 ...
Sameh Dabees +6 more
wiley +1 more source
Advanced Functional Materials, EarlyView.Shellac, a centuries‐old natural resin, is reimagined as a green material for flexible electronics. When combined with silver nanowires, shellac films deliver transparency, conductivity, and stability against humidity. These results position shellac as a sustainable alternative to synthetic polymers for transparent conductors in next‐generation ...
Rahaf Nafez Hussein +4 more
wiley +1 more source
Advanced Functional Materials, EarlyView.P4bm framework in NaNbO3‐Ba(Ti, Hf)O3 ferrodistortive relaxor entails short‐range and highly‐polar ferrodistortive orders. The abundant highly‐polar orders facilitate to increase entropy change, and robust octahedral oxygen tilt enables to impede thermal perturbations.
Feng Li +11 more
wiley +1 more source
Materials & Design, 2017 It has been acknowledged that stresses within a thermal barrier coating (TBC) and its durability are significantly affected by the coating interfaces.
Si Kyaw +4 more
doaj +1 more source
Advanced Functional Materials, EarlyView.ABSTRACT Electronic waste has emerged as a major environmental challenge, driven by the massive consumption and a limited lifetime of modern electronic devices, stimulating the development of sustainable electronics. Here, an all‐biomaterial gelatin‐choline‐citric acid ([Ch][CA]) ionogel is developed as an active binder to realize self‐sintered ...
Lin Guo +10 more
wiley +1 more source
SHAKEDOWN ANALYSIS OF THERMAL BARRIER COATING AND SIMPLIFIED ANALYTIC MODEL
Jixie qiangdu, 2015 Based on wrinkling model,a theoretical model for thermal barrier coating system was established. Using the temperature parameter method,the paper constructed the residual stress field of coating system,built the discrete format of finite element for ...
DONG YaWen, ZHANG BaoFeng
doaj
Receptor‐Free Identification of Toxic Gases Enabled by Hygroscopic Aqueous Salt Films
Advanced Functional Materials, EarlyView.Water as a gas sensor coating sounds impossible—until it stops evaporating. Here, hygroscopic salt solutions (LiCl, LiBr, H3PO4) form non‐drying aqueous films on CNT chemiresistors under ambient air. Gases partition into these liquid layers, sometimes transforming into water, and generate salt‐specific resistance fingerprints across a four‐channel ...
Seongwoo Lee +5 more
wiley +1 more source
Advanced Functional Materials, EarlyView.A soft, dual‐channel hydrogel patch enables simultaneous detection of wound temperature and strain by integrating ion‐diffusion‐mediated thermoelectric and resistive sensing. The conformal design maintains stable performance during motion, capturing subtle inflammatory and mechanical changes for continuous wound monitoring.
Yu Fang +7 more
wiley +1 more source
Advanced Functional Materials, EarlyView.Ferroelectric tunnel junction devices based on epitaxial undoped ferroelectric HfO2 films demonstrate stable switching endurance of over 106 switching cycles, low write voltages of ±3 V, 16 measured resistance states, and neuromorphic capability.
Markus Hellenbrand +13 more
wiley +1 more source
Development of a Vertical Burner Rig Using Methane Flame [PDF]
한국정밀공학회지In this study, we developed a new vertical thermal gradient rig that uses methane-oxygen fuel. We conducted thermal gradient testing on a thermal barrier coating system, with a flame temperature of 1,900°C.
Soo Park +7 more
doaj +1 more source