Results 71 to 80 of about 2,732,388 (277)
Porous materials for thermal management under extreme conditions [PDF]
A brief analysis is presented of how heat transfer takes place in porous materials of various types. The emphasis is on materials able to withstand extremes of temperature, gas pressure, irradiation, etc., i.e.
T.W Clyne +13 more
core +1 more source
Receptor‐Free Identification of Toxic Gases Enabled by Hygroscopic Aqueous Salt Films
Water as a gas sensor coating sounds impossible—until it stops evaporating. Here, hygroscopic salt solutions (LiCl, LiBr, H3PO4) form non‐drying aqueous films on CNT chemiresistors under ambient air. Gases partition into these liquid layers, sometimes transforming into water, and generate salt‐specific resistance fingerprints across a four‐channel ...
Seongwoo Lee +5 more
wiley +1 more source
Development of a Vertical Burner Rig Using Methane Flame [PDF]
In this study, we developed a new vertical thermal gradient rig that uses methane-oxygen fuel. We conducted thermal gradient testing on a thermal barrier coating system, with a flame temperature of 1,900°C.
Soo Park +7 more
doaj +1 more source
A soft, dual‐channel hydrogel patch enables simultaneous detection of wound temperature and strain by integrating ion‐diffusion‐mediated thermoelectric and resistive sensing. The conformal design maintains stable performance during motion, capturing subtle inflammatory and mechanical changes for continuous wound monitoring.
Yu Fang +7 more
wiley +1 more source
Rare-earth Element doped YSZ/YSZ Multilayer Thermal Barrier Coating with High Infrared Reflectivity
The operating temperature of advanced aeroturbine engine increases rapidly for higher working efficiency. Thermal barrier coatings (TBCs) with high temperature capability and thermal insulation effect are required.
YANG Wei, WANG Yufeng
doaj +1 more source
Ferroelectric tunnel junction devices based on epitaxial undoped ferroelectric HfO2 films demonstrate stable switching endurance of over 106 switching cycles, low write voltages of ±3 V, 16 measured resistance states, and neuromorphic capability.
Markus Hellenbrand +13 more
wiley +1 more source
COMPUTATIONAL EVALUATION OF THERMAL BARRIER COATINGS
In the power plant industry, the turbine inlet temperature (TIT) plays a key role in the efficiency of the gas turbine and, therefore, the overall—in most cases combined—thermal power cycle efficiency. Gas turbine efficiency increases by increasing TIT.
Irick, Kevin, Fathi, Nima
openaire +4 more sources
Electrospun Wood‐Derived Biopolymers as Electrodes in Electrochemical Energy Storage Technologies
Electrospinning transforms wood‐derived cellulose and lignin into architecturally defined, binder‐free carbon electrodes with tuneable porosity and functionality. This review shows how fibre design enables decoupled charge and mass transport, enhancing performance across battery systems, while identifying key challenges in spinnability, scalability ...
Michael W. Thielke +3 more
wiley +1 more source
Non-destructive characterisation of structural ceramics using impedance spectroscopy [PDF]
This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.The aim of this project was to explore the potential applications of impedance spectroscopy (IS) in the non-destructive characterisation of structural ...
Wang, Xin
core +4 more sources
The electron beam-physical vapor deposition (EB-PVD) technology was employed to fabricate yttria-stabilized zirconia (YSZ) thermal barrier coatings at different electron beam currents (1.2,1.8,2.4 A). The phase structure and microstructural morphology of
MU Rende +4 more
doaj +1 more source

