Results 91 to 100 of about 534,550 (300)
Powder Optimization Strategies for Binder Jetting Printing of BaTiO3 and Ba0,6Sr0,4TiO3 Ceramics
Advanced Engineering Materials, EarlyView.Powder optimization is investigated to enable binder jetting of BaTiO3 and Ba0.6Sr0.4TiO3 ferroelectric ceramics. The antagonistic relationship between flowability and binder compatibility is addressed through binder impregnation of granulated powders and fumed silica addition to fine powders.
Fanny Pruvost +4 more
wiley +1 more source
Influence of an Oxygen‐Free Atmosphere on Diamond‐Single‐Grain Scratching of Ti–6Al–4V
Advanced Engineering Materials, EarlyView.Single‐grain scratching of Ti–6Al–4V is investigated under controlled, oxygen‐free, and ambient atmospheres using a novel experimental setup with in situ high‐speed imaging. The approach enables direct observation of chip formation and adhesion under suppressed oxidation.
Berend Denkena +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert +6 more
wiley +1 more source
Theoretical and experimental study of thermal contact resistance in a vacuum environment Semiannual status report no. 8, Jun. - Dec. 1965 [PDF]
Thermal contact resistance in vacuum environment using model ...
Clausing, A. M.
core +1 more source
Temperature mapping of operating nanoscale devices by scanning probe thermometry
Nature Communications, 2016 Thermometry using scanning probe techniques allows for the thermal imaging and characterization of devices with nanoscale resolution, however can be hindered by contact-related artefacts.
Fabian Menges +5 more
doaj +1 more source
Heat transfer between surfaces in contact: An analytical and experimental study of thermal contact resistance of metallic interfaces [PDF]
Dimensionless correlation for predicting thermal contact resistance between similar metal surfaces in vacuum ...
Fletcher, L. S., Gyorog, D. A.
core +1 more source
Advanced Engineering Materials, EarlyView.This study investigates laser‐based oxide removal of Cu inserts in oxygen‐free conditions and examines long‐term oxidation kinetics and surface chemistry under different atmospheres via X‐ray photoelectron spectroscopy. Al–Cu compound casting with differently oxidized surfaces is performed, and intermetallic phase formation, morphology, and thermal ...
Timon Steinhoff +9 more
wiley +1 more source
CSEE Journal of Power and Energy SystemsThe press-pack power module with multi-chip layout has drawn increasing attention from industry and academia with its thermal analysis becoming an essential issue.
Yao Chang +7 more
doaj +1 more source
Heat Transfer Measurement and Modeling in Rigid High-Temperature Reusable Surface Insulation Tiles [PDF]
, 2011 Heat transfer in rigid reusable surface insulations was investigated. Steady-state thermal conductivity measurements in a vacuum were used to determine the combined contribution of radiation and solid conduction components of heat transfer.
Cunnington, George R. +2 more
core +1 more source