Results 91 to 100 of about 1,079,849 (348)
Rheocasting versus Die Casting: An Insight into the Low‐Cycle Fatigue Behavior of AlSi7Mg0.6
Advanced Engineering Materials, EarlyView.The study compares rheocast lightweight components with high‐pressure die cast materials regarding microstructure and fatigue behavior. Rheocast process offers higher efficiency due to lower casting temperatures. Despite some microstructural differences, both processes show similar strengths (yield strength 125 MPa, tensile strength 240 MPa).
Julia Richter +4 more
wiley +1 more source
Design and Optimization of Water-cooled Radiator for 6-inch Thyristor Based on Fluent
Kongzhi Yu Xinxi Jishu, 2013 It presents a water-cooled radiation system for 6-inch thyristor and its model. With Fluent software, radiation process is simulated through finite element analysis as well as standard k- ε turbulence model, which follows computations on both N-S ...
XIONG Hui +4 more
doaj
An investigation on thermal shock resistance of ZrB2-SiC composites
, 2021 Bahador Abolfathnezhad +2 more
openalex +1 more source
Significance of thermal contact resistance in two-layer thermal-barrier-coated turbine vanes [PDF]
The importance of thermal contact resistance between layers in heat transfer through two layer, plasma sprayed, thermal barrier coatings applied to turbine vanes was investigated.
Gaugler, R. E., Liebert, C. H.
core +1 more source
Can Ti‐Based MXenes Serve as Solid Lubricants for Brake Applications? A Tribological Study
Advanced Engineering Materials, EarlyView.This study explores the first implementation of Ti‐based MXenes materials in brake pad friction composite material. The resulting composite material exhibits a 48% reduction in the wear rate; alongside significant improvements are observed for thermal and mechanical properties.
Eslam Mahmoud +7 more
wiley +1 more source
Thermal shock and erosion resistant tantalum carbide ceramic material [PDF]
, 1978 Ceramic tantalum carbide artifacts with high thermal shock and mechanical erosion resistance are provided by incorporating tungsten-rhenium and carbon particles in a tantalum carbide matrix. The mix is sintered by hot pressing to form the ceramic article
Honeycutt, L., III, Manning, C. R.
core +1 more source
Advanced Engineering Materials, EarlyView.The results demonstrate a simulation‐driven workflow that applies LSB topology optimization with additive manufacturing constraints to mission‐specific load cases, integrating European Cooperation for Space Standardization compliant verification and manufacturability to develop structurally efficient rover suspension components.
Stelios K. Georgantzinos +11 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé +5 more
wiley +1 more source
Hydraulic resistance of thermal deaerators of thermal power stations (TPS) with jet-film contact devices [PDF]
, 2017 И. Н. Мадышев +2 more
openalex +1 more source
Thermal and electrical contact conductance studies [PDF]
Prediction of electrical and thermal contact resistance for pressed, nominally flat contacts is complicated by the large number of variables which influence contact formation.
Nilles, M., Vansciver, S. W.
core +1 more source