Results 91 to 100 of about 86,061 (298)
Exploring structure based charge transport relationships in phenyl diketopyrrolopyrrole single crystals using a 2D π–π dimer model system [PDF]
, 2017 This document is the Accepted Manuscript version of the following article: Jesus Calvo-Castro, and Callum J. McHugh, ‘Exploring structure based charge transport relationships in phenyl diketopyrrolopyrrole single crystals using a 2D π–π dimer model ...
Calvo-Castro, Jesus, McHugh, Callum J.
core +4 more sources
Advanced Materials Interfaces, EarlyView.Procalcitonin is a key biomarker for bacterial infections, but conventional detection methods are often time‐consuming. Here, we present an electrochemical sensor based on highly conductive Ti3C2Tx MXene combined with PEDOT:PSS, enabling direct antibody immobilization, while a bovine serum albumin coating provides antifouling protection.
Angelika Banaś +6 more
wiley +1 more source
Polyterthiophenes incorporating 3,4-difluorothiophene units : application in organic field-effect transistors [PDF]
, 2010 Two terthiophenes bearing core fluorinated thienyl units have been synthesised as potential semiconductor materials for organic field-effect transistors.
Crouch, David J. +4 more
core +1 more source
Topological Point Defects in SmC* Liquid Crystals Under Mechanical Disturbance
Advanced Materials Interfaces, EarlyView.Tangetial air jet shear inducess island formation and nucleates topological point defects in uniform SmC films. Island bounded by edge dislocation loops shrink and transform into isolated point defects under continued shear. Mechanical perturbatio provides a controllable route for defect engineering in smectric liquid crystal thin films.
Gunganist Kongklad +3 more
wiley +1 more source
Adsorption of Thiophenic Compounds from n-Hexane Using Activated Carbon Adsorbent
مجلة النهرين للعلوم الهندسية, 2015 The aim of this work is to study the adsorption of thiophenic compounds (thiophene and benzo thiophene) on activated carbon by studying the effects of various important variables such as height of the bed (4, 6, and 8 cm) , inlet sulfur concentration (50,
Yousra Saber Kareem
doaj
Mapping the perturbation potential of metallic and dipolar tips in tunneling spectroscopy on MoS2 [PDF]
, 2019 Scanning tunneling spectroscopy requires the application of a potential difference between the sample and a tip. In metal-vacuum-metal junctions, one can safely assume that the potential is constant along the metallic substrate.
Bogdanoff, Nils +6 more
core +2 more sources
Chemically Doped Conductive Polymers for Wearable Health Monitoring
Advanced Materials Technologies, EarlyView.Among conductive polymers, poly(3,4‐ethylenedioxythiophene):poly(styrenesulfonate) (PEDOT:PSS), polyaniline (PANI), and polypyrrole (PPy) are the most studied and applied. Chemical doping significantly boosts intrinsic conductivity and mechanical robustness.
Mengdi Zuo +5 more
wiley +1 more source
Advanced Materials Technologies, EarlyView.Printed organic thermoelectric generators (OTEGs) enable flexible and sustainable energy harvesting from low‐grade heat. This Perspective critically assesses recent advances in printable thermoelectric materials, 2D and 3D device architectures, and current performance limits of printed OTEGs.
Vijitha Ignatious +5 more
wiley +1 more source
EFSA Journal, 2013 The Panel on Food Contact Materials, Enzymes, Flavourings and Processing Aids of the European Food Safety Authority was requested to consider evaluations of flavouring substances assessed since 2000 by the Joint FAO/WHO Expert Committee on Food Additives
EFSA Panel on Food Contact Materials, Enzymes, Flavourings and Processing Aids (CEF)
doaj +1 more source
Pulling and Stretching a Molecular Wire to Tune its Conductance
, 2015 A scanning tunnelling microscope is used to pull a polythiophene wire from a Au(111) surface while measuring the current traversing the junction. Abrupt current increases measured during the lifting procedure are associated to the detachment of molecular
Björk J. +9 more
core +5 more sources