Results 121 to 130 of about 8,331 (256)
, 2004 This study deals with the applicability of a single tooth bending fatigue test in the evaluation of gear blank manufacturing methods using three point bending loading.
Altinbalik, MT, Akata, E, Çan, Y
core +1 more source
Advanced Engineering Materials, EarlyView.This review highlights advances in lightweight, lead‐free polymer nanocomposites for diagnostic X‐ray shielding. By linking filler chemistry, dispersion, architecture, and photon interaction mechanisms, it establishes structure–performance relationships guiding material design.
Aklilu G. Messele +2 more
wiley +1 more source
Influence of Geometric Design on Mechanical Performance of Auxetic Metastructure
Advanced Engineering Materials, EarlyView.Strategic geometric reinforcement transforms auxetic performance. This study evaluates 3D‐printed arrowhead metastructures, revealing that a modified design with local ring reinforcement suppresses premature failure to achieve superior energy absorption and structural efficiency.
Muhammad Gulzari +3 more
wiley +1 more source
A Dislocation Perspective on Strength and Toughness in Ceramics
Advanced Engineering Materials, EarlyView.Dislocations in ceramics enjoy a long but yet under‐appreciated history. The three research waves for dislocations in ceramics highlight the topic evolution over the last 90 years. This review focuses on the impact of dislocation on strength and toughness in ceramics.
Xufei Fang
wiley +1 more source
, 2013 Correlation between fracture load (measured using a three-point bending test) and areal BMD (measured using DXA).
Ming-Tzu Tsai (296145) +6 more
core +1 more source
Experimental Characterization of Mycelium‐Based Composites Under Multiple Loading Conditions
Advanced Engineering Materials, EarlyView.This study examines the mechanical response of mycelium‐based composites under compression, shear, and tension using mechanical testing and imaging methods. The comparison between unpressed and hot‐pressed specimens shows that hot pressing is associated with higher compression and shear stiffnesses.
Shaghayegh Elahi +5 more
wiley +1 more source
, 2017 In this work, bendability evaluation of three sheet metals, a galvanized steel (JAC780Y), a stainless steel (SUS304) and a cold rolled steel (SPCC) was precisely investigated using an acoustic emission (AE) technique.
Nopparat Seemuang +5 more
core +1 more source
Comparison of Triply Periodic Minimal Surface Energy Absorbers Under Uniaxial Compressive Loading
Advanced Engineering Materials, EarlyView.This study investigates LCD 3D printed Triply Periodic Minimal Surface (TPMS) structures as mechanical energy absorbers. By comparing various base designs and layered combinations under uniaxial compression, it identifies that a Diamond‐Gyroid sandwich structure offers superior performance.
Sergej Grednev +2 more
wiley +1 more source
Oil & Gas Science and Technology, 2015 The side crushing test is commonly used to characterize the mechanical strength of catalyst supports. However its interpretation is complex for cylindrical supports due to their irregular geometry and the various fracture modes induced. A better analysis
Staub D. +4 more
doaj +1 more source
Research of Method for Solving Relaxation Modulus Based on Three-Point Bending Creep Test
, 2019 A method was developed for solving the relaxation modulus of high viscosity asphalt sand (HVAS) based on the three-point bending creep test, and was verified by comparison with experimental results.
Xuezhong Yuan +3 more
core +1 more source