Results 111 to 120 of about 66,854 (228)
Properties data for opening the Galileo's partially unfurled main antenna [PDF]
An investigation was conducted into the friction and wear behavior of both unlubricated and dry-film-lubricated (Tiolube 460) titanium alloy (Ti-6Al-4V) in contact with an uncoated high-nickel-content superalloy (Inconel 718) both in vacuum and in air ...
Miyoshi, Kazuhisa, Pepper, Stephen V.
core +1 more source
COMPORTAMENTO QUASI-STATICO DI PROVINI INTAGLIATI IN LEGA TI-6AL-4V IN METANOLO [PDF]
, 2013 The use of titanium alloys in the automotive, aerospace and naval industry is always increasing, due to their favorable strength to mass ratio and to their excellent fatigue performances.
BARAGETTI, SERGIO +2 more
core
Effect of creep in titanium alloy Ti-6Al-4V at elevated temperature on aircraft design and flight test [PDF]
Short-term compressive creep tests were conducted on three titanium alloy Ti-6Al-4V coupons at three different stress levels at a temperature of 714 K (825 F).
Jenkins, J. M.
core +1 more source
Materials Research ExpressWire-feed laser metal deposition (LMD-W) offers a high deposition rate and low cost, making it an effective solution for reducing costs and enhancing efficiency in manufacturing large-scale titanium aerospace components.
Chenyang Wang +4 more
doaj +1 more source
Fatigue behavior of SiC reinforced titanium composites [PDF]
The low cycle axial fatigue properties of 25 and 44 fiber volume percent SiC/Ti(6Al-4V) composites were measured at room temperature and at 650 deg C. The S-N curves for the composites showed no anticipated improvement over bulk matrix behavior at room ...
Bhatt, R. T., Grimes, H. H.
core +1 more source
Caracterização microestrutural da camada de NiCrAlY sobre Ti-6Al-4V processado por laser de Yb:fibra [PDF]
, 2022 Renata Jesuina Takahashi +4 more
openalex +1 more source
Virtual and Physical PrototypingLaser powder bed fusion (LPBF) of titanium alloys has demonstrated significant potential in high-value-added fields such as aerospace and biomedical. However, the highly non-stationary thermal history and inherent limitations of the LPBF process lead to ...
Chenbing Ni +8 more
doaj +1 more source
Evaluation of a thermoplastic polyimide (422) for bonding GR/PI composite [PDF]
A hot-melt processable copolyimide previously studied and characterized as an adhesive for bonding Ti-6Al-4V was used to bond Celion 6000/LARC-160 composite. Comparisons are made for the two adherend systems.
Progar, Donald J.
core +1 more source
Phase composition and microstructure of Ti-6Al-4V alloy after hydrogen-plastic working [PDF]
, 2010 The influence of combination of thermohydrogen treatment and plastic working of Ti-6Al-4V (VS6 Ru) titanium alloy on its microstructure and phase composition has been investigatedyesBelgorod State ...
Ivanov, M. B. +3 more
core