Results 41 to 50 of about 746,485 (140)
Analysis of tribological processes at timing belt's tooth flank [PDF]
, 2009 The paper presents basic tribomechanical systems in timing belt drives. Analysis of tribomechanical system belt's tooth - belt pulley's tooth, in which the largest value of friction force occurs, is conducted.
Miloradović, Nenad +2 more
core
Wind Energy, Volume 29, Issue 9, September 2026.ABSTRACT With the development of ultra‐compact wind turbines, the electromechanical coupling dynamic characteristics of integrated gearbox‐generator systems in their drive trains have attracted increasing attention. To reveal these characteristics, an electromechanical coupling dynamic model is established using the lumped parameter method and the ...
Yin Runsheng +3 more
wiley +1 more source
Mathematical model of the worm wheel tooth flank of a double-enveloping worm gear
, 2021 This paper presents a novel method for determining the worm wheel tooth flank surface. The worm wheel model is developed according to the theory of gearing and the gear generation mechanism. Two cases are considered simultaneously.
Mariusz Sobolak +2 more
core +1 more source
Geochemistry, Geophysics, Geosystems, Volume 27, Issue 9, September 2026.Abstract Megathrust slip behavior in subduction zones can vary along‐strike, yet the mechanisms driving this variability remain uncertain. The Middle America trench offshore Mexico provides an ideal setting to investigate the structural controls on megathrust slip behavior.
Davis Hagemeier +10 more
wiley +1 more source
On the Mutual Relation Between Contact Ratio and Crack Propagation in the Tooth Root of Spur Gears
Fatigue &Fracture of Engineering Materials &Structures, Volume 49, Issue 9, Page 3896-3908, September 2026.ABSTRACT This work investigates the mutual relationship between contact ratio and tooth root crack propagation in spur gears, with particular focus on the influence of meshing stiffness and load sharing on the tooth root lifetime. An experimental case study originally reported by Rettig, in which SN curves of gears with similar geometry but different ...
Lorenzo Valsecchi +5 more
wiley +1 more source
, 2019 To increase the life of slewing reducers, the reliability of their gearboxes is essential. They should be designed, simulated, and tested considering the installation environment and actual load conditions.
Cho, Seung-Je +7 more
core +1 more source
Study on Influence of Ultrasonic Vibration Lapping Gear on the Machining Quality of Tooth Flank
, 2019 Two pairs of hypoid gears with 7/37 and 8/41 teeth are selected as experimental objects. The ultrasonic lapping of gear is carried out on the modified rolling inspection machine Y9550， ultrasonic vibration frequency is 16 kHz， ultrasonic grinding time is
Jianjun Yang, Derong Zhu, Xiaozhong Deng
core +1 more source
Tooth Flank Mismatch Meshing Analysis for Spiral Bevel Gear Based on Tilt Cutting Method
, 2019 The analysis method of tooth flank mismatch meshing is studied for the spiral bevel gear of automobile drive axle. Firstly，the mathematical model of tilt cutting method is established，and the cradle angle is derived according to the meshing equation，so ...
Juhua Huang +5 more
core +1 more source
Jixie chuandongObjectiveTooth flank fracture is a contact fatigue failure mode of high-cycle/ultra-high-cycle fatigue damage where cracks initiate due to material damage at deep locations inside the tooth.
WANG Xiaopeng +7 more
doaj
Tooth fracture during or after dental treatment [PDF]
, 2014 During dental treatment, if a tooth were fractured suddenly by unnoticed tooth crack or vertical root fracture, it would be very embarrassing and frustrating experiences to dentists.
노병덕
core