Results 11 to 20 of about 557,220 (279)
An optical torque transducer for high-speed cutting
Measurement Science and Technology, 2006 In this paper, the design and manufacture of an angular twist-type optical torque transducer is described. It is based on the measurement of the angular twist of a stainless steel wire gauge proportional to the torque transmitted, through two optical reflective sensors.
PANTALEO, ANTONIO +2 more
openaire +2 more sources
Design, construction and performance analysis of dynamic torque transducer
Journal of Innovations in Engineering Education, 2023 Most of the dynamic torque measurement devices present are not easy to afford and accurate for higher shaft speed, at the same time, especially in the case of Micro-hydropower stations where dynamic torque fluctuates and requires constant monitoring.
Dipesh Karki, H. Dura, Laxman Poudel
semanticscholar +1 more source
Solutions for Torque and Speed Measurement on Electric Machine Controllers Test Benches
Revista Elektrón, 2021 The continuous search for improvement in electromechanical developments requires a clear understanding of the torque measurement required in each application. The decisions made will have a profound impact on the quality and cost of the results.
Alejandro Fabio Veyrat Durbex +2 more
doaj +1 more source
Measurement + Control, 2023 The input and output torque testing is crucial for improving the quality of Industry robot reducers. In this study, the TMMISR and TMMOSR for a vertical-type robot reducer detector were designed.
Zhen Yu +3 more
doaj +1 more source
Stability Studies of Torque Transducers [PDF]
Measurement Science Review, 2011 The present paper discusses the stability studies carried out on a small number of torque transducers over the years with capacities ranging from 10 Nm to 1000 Nm. The torque transducers have been calibrated using the torque standard machine based on the written standard calibration procedure.
Anil Kumar, Harish Kumar
openaire +1 more source
Journal of Baghdad College of Dentistry, 2023 Background: Measuring implant stability is an important issue in predicting treatment success. Dental implant stability is usually measured through resonance frequency analysis (RFA).
Alamin Y Dhahi +2 more
doaj +1 more source
Comparing original and universal screwdrivers in terms of torque loss in the abutment screw
Indian Journal of Dental Sciences, 2021 Objective: The aim of this study was to examine whether tightening or loosening the abutment screw results in torque loss and whether there is a difference in this respect between original screwdrivers and universal screwdrivers.
Vasilios Alevizakos +4 more
doaj +1 more source
Analysis of suitable of traction model for sandy clay loam soils on farm use of tractor
Journal of Agriculture and Food Research, 2021 A mechatronic-based embedded system was used to measure and display the dynamic wheel axle torque and tractive force of different tractor-implement combinations. It included a special transducer to measure drive wheel torque of a tractor, and an embedded
A. Ashok Kumar, V.K. Tewari
doaj +1 more source
An investigation on the effect of humidity on the zero signal of a strain gauge measuring system
Universitas Scientiarum, 2018 Humidity is one of the most important ambient factors influencing torque calibration readings. The present study addresses the effect of relative humidity on the readings of reference torque transduction and amplification devices.
K. M. Khaled, G. M. Mahmoud
doaj +1 more source
Sensors, 2019 Ultrasonic transducer is a piezoelectric actuator that converts AC electrical energy into ultrasonic mechanical vibration to accelerate the material removal rate of workpiece in rotary ultrasonic machining (RUM).
Jian-Guo Zhang +4 more
doaj +1 more source