Measurement of frictional torque of a directacting valvetrain using a shaft-to-shaft torque transducer to study the effect of Laser Surface Texturing on friction reduction [PDF]
MATEC Web of ConferencesThe study of tribological applications requires measuring various parameters, including RPMs, friction, and wear. The useful information is sometimes not readily available in a measurement and requires further postprocessing to extract that information ...
Siddiqui Muhammad Rizwan +6 more
doaj +1 more source
Aspects Concerning the Torque Ripple Control of the Brushless DC Motor
Advances in Electrical and Computer Engineering, 2013 This paper deals with two advanced numerical structures to control the electromagnetic torque ripple of Brushless Direct Current Motors (BLDCM), indirectly achieved by phase currents control and directly by the Direct Torque Control (DTC) technique. In
BALUTA, G., URSANU, G.
doaj +1 more source
Development and Characterization of a Compact Device for Measuring the Braking Torque of a Vehicle
Sensors, 2020 In this article, a new force transducer is designed, developed and built for the measurement of braking forces in the wheel rim of a motor vehicle. The parameters of the transducer design are justified using numerical simulation.
Ester Olmeda +3 more
doaj +1 more source
A high - precision measurement chain for reference purposes
Measurement: Sensors, 2021 Reference transducers not only for high pressure (GPa) but also for high force (MN) and high torque (MN▪m) have been based on foil-type strain gauges for decades, due to their excellent signal-to-noise ratio and established, well-proven technology. Thus,
André Schaefer
doaj +1 more source
Design study for a multicomponent transducer for wind turbine test benches [PDF]
Journal of Sensors and Sensor Systems, 2020 This paper covers the design study of a multicomponent transducer (MCT) for wind turbine test benches. The MCT will cover the characteristics of wind turbines in the power range of up to 6 MW.
J. Gnauert +4 more
doaj +1 more source
A review of using the force/torque sensor in robotics application [PDF]
, 2020 Nowadays, force/torque sensors ubiquitous in the robotics field. Most of the robots on the assembly line use a force/torque sensor in a complex assembly process.
Abdul Manaf, Mohamad Shukri +3 more
core
Sensors, 2018 This paper presents the design of a novel small-angle transducer characterized by a simple structure, fast response and very low reaction torque. A theoretical model is presented which describes the linear relationship between the output voltage and the ...
Zongyu Chen, Jiuzhi Dong, Xingfei Li
doaj +1 more source
Characterisation of contact pressure distribution in bolted joints [PDF]
, 2006 The quantification of contact area and pressure distribution in a bolted joint is essential information, as it determines the integrity of the coupling. Current bolted joint design standards are based on analytical solutions of the pressure distribution,
Arakawa +11 more
core +1 more source
Investigating wind turbine dynamic transient loads using contactless shaft torque measurements
The Journal of Engineering, 2019 The wind industry is showing increasing awareness about the importance of long-term direct shaft mechanical torque measurements to fully understand wind turbine (WT) dynamics, adopt proactive solutions for extreme load mitigation and enhance condition ...
Donatella Zappalá +3 more
doaj +1 more source
Development of a non-contact torque transducer based on the laser speckle contrast method [PDF]
Journal of Sensors and Sensor Systems, 2017 When a torque measurement is required, torque transducers show many drawbacks during their use: the usual limits are the need for contact and the effects on shaft line parameters. A new approach is proposed in this work: a non-contact torque meter for
A. Garinei, R. Marsili
doaj +1 more source