Results 21 to 30 of about 643,132 (282)
Sound Field Modeling Method and Key Imaging Technology of an Ultrasonic Phased Array: A Review
Applied Sciences, 2022 An ultrasonic phased array consists of multiple ultrasonic probes arranged in a certain regular order, and the delay time of the excitation signal sent to each array element is controlled electronically.
Qian Xu, Haitao Wang
doaj +1 more source
Applied Sciences, 2023 The basic principle of ultrasound is to relate the time of flight of a received echo to the location of a reflector, assuming a known and constant velocity of sound.
Michał K. Kalkowski +5 more
doaj +1 more source
On Dispersion Compensation for GAW-Based Structural Health Monitoring
Sensors, 2023 Guided acoustic waves (GAW) have proven to be a useful tool for structural health monitoring (SHM). However, the dispersive nature of commonly used Lamb waves compromises the spatial resolution making it difficult to detect small or weakly reflective ...
Alexander Backer +2 more
doaj +1 more source
Total focusing method concept. [PDF]
, 2019 Total focusing method concept.
Yuzhong Li (738973) +2 more
core +1 more source
IEEE Access, 2020 Ultrasonic phased array technology is used in various fields. Traditional full phased arrays place elements in every position of a uniform lattice with half-wavelength spacing between the lattice points, so the hardware cost is very high.
Han Zhang +3 more
doaj +1 more source
Laser-induced ultrasonic measurements for the detection and reconstruction of surface defects
Acta Acustica, 2021 Laser-induced ultrasonic measurement is a non-contact non-destructive technology that can be employed for the testing and assessment of surface defects.
Qian Feiming +5 more
doaj +1 more source
Characterisation of small embedded two-dimensional defects using multi-view Total Focusing Method imaging algorithm [PDF]
, 2021 Defect characterisation is an essential step of nondestructive testing which aims to determine the shape and the size of a defect once detected. The imaging algorithm multi-view Total Focusing Method (TFM) has been successfully used to accurately size ...
Bevan, Rhodri L T +8 more
core +1 more source
Sensors, 2020 Plane wave imaging (PWI) is attracting more attention in industrial nondestructive testing and evaluation (NDT&E). To further improve imaging quality and reduce reconstruction time in ultrasonic imaging with a limited active aperture, an optimized PWI ...
Hao Sui +3 more
doaj +1 more source
Plane Wave Imaging through Interfaces
Sensors, 2021 Plane Wave Imaging (PWI) has been recently proposed for fast ultrasound inspections in the Non-Destructive-Testing (NDT) field. By using a single (or a reduced number) of plane wave emissions and parallel beamforming in reception, frame rates of hundreds
Guillermo Cosarinsky +2 more
doaj +1 more source
Encoded Total Focusing Method for Improving Data Acquisition Rate
Proceedings of the International Conference on Bioimaging, 2015 Synthetic aperture imaging techniques are capable to obtain high quality images, fully focused in both transmission and reception. However, these techniques require to perform so many emissions as elements in the array to acquire RF data. This requirement decreases acquisition rate and can result in tissue motion artifacts because of the phase
César Gutiérrez Fernández +2 more
openaire +1 more source