Process design and life anylysis of tundish lining
Metalurgija, 2021 The working lining of continuous casting tundish is made of magnesia dry material with short service life. It is found that the refractory lining cast steel zone is the key to influence the service life of tundish.
J. H. Zhang, Y. X. Chen, D. Z. Yang
doaj
The Adjustment of the Tundish Water Model of Continuous Casting [PDF]
Archives of Metallurgy and Materials, 2022 Whereas approximately 96.3% of the steel produced worldwide is made by continuous casting, great emphasis is put on the superior efficiency of this process.
P. Blaško +8 more
doaj +1 more source
Research on the Relative Placement Angle of the Induction Heater and the Channel in a Four-Channel Induction-Heating Tundish [PDF]
Materials (Basel)In order to optimize the application effect of induction heating (IH) tundishes, a four-channel IH tundish is taken as the research object. Based on numerical simulation methods, the influence of different relative placement angles of induction heaters ...
Chen X +5 more
europepmc +2 more sources
In-situ steel solidification imaging in continuous casting using magnetic induction tomography [PDF]
, 2020 : Solidification process in continuous casting is a critical part of steel production. The speed and quality of the solidification process determines the quality of final product.
Barbero, J +6 more
core +3 more sources
Study and Application on Physical Simulation of Single Thick Slab Flow Tundish
Teshugang, 2022 In order to obtain a more reasonable 50 t tundish flow control device, a single flow tundish water model with a geometrical similarity ratio of 1:4 is established, and physical simulation tests are carried out to study the effects of different flow rates
Jiang Xuefeng +3 more
doaj
Chemically induced solidification : a new way to produce thin solid-near- net shapes [PDF]
, 2016 In-situ observation of the solidification of high carbon steel (4 wt% C) through decarburization has been carried out as a feasibility study into reducing high power usage and high CO2 production involved in steel making. Decarburization has been carried
C. Molloseau +13 more
core +1 more source
Optimization of flow control devices in a 40-t single strand tundish
工程科学学报, 2015 An optimization of flow control "devices in a 40-t single strand continuous casting tundish was carried out by water modeling experiments and industrial experiments. Three cases were considered during the experiments, i.
ZHAO Li-hua, WANG Min, LI Ning
doaj +1 more source
Finite element analysis applied to redesign of submerged entry nozzles for steelmaking [PDF]
, 2011 The production of steel by continuous casting is facilitated by the use of refractory hollow-ware components. A critical component in this process is the submerged entry nozzle (SEN).
A Hendry +7 more
core +1 more source
steel research international, EarlyView.The experiments and simulations demonstrate that, in general, alternative carbon sources can decrease fossil CO2 without adversely impacting EAF process and product. High plastics and tires ratios cause unsafe conditions and poor slag foaming. Hydrogen in EAF burners decreases CO2 but increases water vapor, which can raise the hydrogen content in ...
Ismael Matino +7 more
wiley +1 more source
Flow Behavior of Liquid Steel in Fewer Strands Casting of Six-Strand Bloom Tundish
Metals, 2023 In continuous casting, it is common to close single or multiple submerged nozzles of multi-strands tundish to adapt to production rhythm due to insufficient liquid steel or equipment failure.
Xianyang Wang +6 more
doaj +1 more source