Factors Affecting Plunge Grinding Force [PDF]
, 1980 Grinding force has a close relation to grinding inputs such as grinding wheel, work material, interference condition, grinding speed, grinding fluid and machine condition, and therefore varies widely with grinding inputs.
Nakajima, Toshikatsu, Uno, Yoshiyuki
core +1 more source
Geophysical Monograph Series, Page 97-104., 2020 This book is Open Access. A digital copy can be downloaded for free from Wiley Online Library.
Explores the behavior of carbon in minerals, melts, and fluids under extreme conditions
Carbon trapped in diamonds and carbonate-bearing rocks in subduction zones are examples of the continuing exchange of substantial carbon ...
Daniele Cherniak +2 more
wiley +1 more source
Determination of micro-scale plastic strain caused by orthogonal cutting [PDF]
, 2008 An electron beam lithography technique has been used to produce microgrids in order to measure local plastic strains, induced during an orthogonal cutting process, at the microscopic scale in the shear zone and under the machined surface. Microgrids with
Allais +31 more
core +1 more source
Crystals, 2023 The grinding force is an important index during the grinding process, which affects the surface quality and other aspects after machining. However, the research on the grinding force of ceramic matrix composites assisted by two-dimensional ultrasonic ...
Yunguang Zhou +5 more
doaj +1 more source
Scaling properties of a low-actuation pressure microfluidic valve [PDF]
, 2004 Using basic physical arguments, we present a design and method for the fabrication of microfluidic valves using multilayer soft lithography. These on-off valves have extremely low actuation pressures and can be used to fabricate active functions, such as
Anna Pandolfi +10 more
core +1 more source
Metals, 2023 Analytical cutting models have recently become quite widespread due to the simplicity and rapidity of calculations as well as the stability of the solutions.
Michael Storchak, Maria A. Lekveishvili
doaj +1 more source
Undeformed Chip Shape in Angular Grinding [PDF]
, 1975 This paper describes the basic boundary conditions in angular grinding, which is widely applied as a high efficiency machining and where a complicated-shaped workpiece is ground at the same time.
Nakagawa, Heisaburo +1 more
core +1 more source
Simulation of a finishing operation : milling of a turbine blade and influence of damping [PDF]
, 2012 Milling is used to create very complex geometries and thin parts, such as turbine blades. Irreversible geometric defects may appear during finishing operations when a high surface quality is expected.
BALMES, Etienne +4 more
core +5 more sources
An investigation on the mechanics of nanometric cutting and the development of its test-bed [PDF]
, 2003 The mechanics of machining at a very small depth of cut (100 nm or less) is not well understood. The chip formation physics, cutting forces generation, resulting temperatures and the size effects significantly affect the efficiency of the process and ...
Cheng, K, Guo, XJ, Holt, R, Luo, X
core +2 more sources
Electroplastic cutting influence on power consumption during drilling process [PDF]
, 2016 The aim of this study is to report the use of non-conventional material removal process technique. It was found that electropulses (EPs) assisted drilling process improves the material machinability based on the eletroplastic influence.
González Rojas, Hernan Alberto +3 more
core +2 more sources