Results 41 to 50 of about 9,521 (205)

Smart Loads for Voltage Control in Distribution Networks [PDF]

open access: yes, 2015
This paper shows that the smart loads (SLs) could be effective in mitigating voltage problems caused by photovoltaic (PV) generation and electric vehicle (EV) charging in low-voltage (LV) distribution networks.
Akhtar, Z, Chaudhuri, B, Hui, S
core   +2 more sources

Balance control of grid currents for UPQC under unbalanced loads based on matching-ratio compensation algorithm [PDF]

open access: yes, 2018
In three-phase four-wire systems, unbalanced loads can cause grid currents to be unbalanced, and this may cause the neutral point potential on the grid side to shift.
Chai, Xiuhui   +5 more
core   +1 more source

Contribution of using a photovoltaic unified power quality conditioner in power quality improvement

open access: yesElectrical engineering & Electromechanics
Introduction. With the increasing complexity of power systems and the integration of diverse energy sources, issues such as voltage sags, swells, and signal distortions have emerged as critical challenges.
C. Bousnoubra, Y. Djeghader, H. Belila
doaj   +1 more source

Analisis Penggunaan Unified Power Quality Conditioner (UPQC) pada Sistem Daya Elektrik

open access: yesJurnal EECCIS (Electrics, Electronics, Communications, Controls, Informatics, Systems), 2014
Paper ini berisi tentang analisis dan pemodelan Unified Power Quality Conditioner (UPQC) y a n g digunakan untuk memperbaiki profil tegangan di PT. Kutai Timber indonesia (KTI) akibat penurunan tegangan sesaat (voltage sag) karena adanya gangguan tem ...
Rachmadi Setiawan   +2 more
doaj   +1 more source

Power Quality Improvement Using Unified Power Quality Conditioner (UPQC) [PDF]

open access: yes, 2016
The advance use of power electronic devices introduces harmonics in the supply system which creates a problem in the quality of power delivered. Good Power Quality is very much important for our day to day use of appliances in both industrial and ...
Anand , Piyush
core  

New control algorithm for single-phase series active power filter [PDF]

open access: yes, 2015
This paper presents a single-phase Series Active Power Filter (Series APF) for mitigation of the load voltage harmonic content, while maintaining the voltage on the DC side regulated without the support of a voltage source.
Afonso, João L.   +3 more
core   +1 more source

Review on Design of Improved Unified Power Quality Conditioner for Power Quality Improvement [PDF]

open access: yes, 2022
Non-linear loads are frequently affected by power quality (PQ). Resonance mechanisms, condenser overheating, and other performance-degrading consequences are all caused by harmonic currents. Voltage sags are common in low-voltage systems.
Jain, Bharat Bhushan, Joshi, Nandini
core   +2 more sources

Power quality enhancement of grid-integrated solar photovoltaic system with unified power quality conditioner

open access: yesElectrical engineering & Electromechanics
Introduction. To enhance the quality of power and ensure a consistent electricity supply, this study proposes the utilization of a unified power quality conditioner (UPQC) system integrated with solar photovoltaic (PV) technology. The innovation involves
M. Manohara   +5 more
doaj   +1 more source

Hybrid fuzzy back-propagation control scheme for multilevel unified power quality conditioner

open access: yesAin Shams Engineering Journal, 2018
To increase the lifetime and performance of equipment in utility distribution systems, the enhancement of power quality is essential. In this paper, to enhance the power quality, we present the design of a hybrid fuzzy back-propagation control scheme for
V. Veera Nagireddy   +2 more
doaj   +1 more source

Power Quality Mitigation by Generalized Unified Power Quality Conditioner

open access: yesInternational Journal of Recent Technology and Engineering (IJRTE), 2019
The network reconfiguring and compensating devices are the two different types of custom power solutions. The network reconfiguration devices consist of switchgear with current breaking, current restrict and current sending devices. The compensating device will compensate load by correcting power factor, unbalance etc.
Veeresha K B, Dr. Thejaswi A H
openaire   +1 more source

Home - About - Disclaimer - Privacy