Results 81 to 90 of about 309,785 (305)

Handbook of Establishing and Maintaining Oxygen‐Free Atmospheres

Advanced Engineering Materials, EarlyView.
This study presents a practical framework for creating oxygen‐free atmospheres at ambient pressure using silane‐doped inert gases. The results show that ultra‐low oxygen levels and strongly reduced water content can be achieved through controlled silane dosing, drying systems, and sensor monitoring.
Sascha Jan Zimmermann, René Gustus, Lienhard Wegewitz, Wolfgang Maus‐Friedrichs   +3 more
wiley   +1 more source

Comparative study of the loss of vitamin C in chalarina (Casimiroa edulis) by four methods of dehydration

Scientia Agropecuaria, 2010
The aim of this study was to compare the loss of chalarina vitamin C after applying four methods of dehydration: vacuum osmotic dehydration combined with convective drying, convective drying, osmotic dehydration combined with vacuum freeze-drying, and ...
Judith Castañeda, Hubert Arteaga, Raúl Siche, Gilbert Rodriguez   +3 more
doaj   +1 more source

Effects of different types of drying on the nutritive value of proteins in the fishmeals [PDF]

, 1965
A comparative study on the effect of different types of drying on the nutritive value of the proteins in the different fishmeals of known history was made.
Bose, A.N., Kamasastri, P.V., Ramananda Rao, D.   +2 more
core  

Application of Raman and Photoluminescence Spectroscopy to MgO‐C Refractories

Advanced Engineering Materials, EarlyView.
Visible to near infrared luminescence of MgO is studied on MgO‐C bricks and nominally pure MgO powder, with focus on two similar sharp high‐intensity signals, at 699 and 871 nm, each surrounded by symmetrical sidebands. The nature of these sidebands is investigated by temperature‐dependent spectroscopic measurements, confirming phonon involvement by ...
Julia Richter, Felix Drechsler, Till M. J. Stadtmüller, Cameliu Himcinschi, Christos G. Aneziris, Jens Kortus   +5 more
wiley   +1 more source

DEVELOPMENT OF A NOVEL ENERGY EFFICIENT ADSORPTION DRYER WITH ZEOLITE FOR HEAT SENSITIVE PRODUCTS

, 2010
Drying is a basic operation in wood, food, pharmaceutical and chemical industry. The operation is important to enhance the preservation properties of agriculture crops and pharmaceutical products, to reduce the costs for transportation, to increase ...
Djaeni, M
core  

Monolith formation and ring-stain suppression in low-pressure evaporation of poly(ethylene oxide) droplets [PDF]

, 2012
When droplets of dilute suspensions are left to evaporate the final dry residue is typically the familiar coffee-ring stain, with nearly all material deposited at the initial triple line (Deegan et al, Nature, vol. 389, 1997, pp. 827-829).
David J. Fairhurst, Doi, Khellil Sefiane, Kyle A. Baldwin, Martin E. R. Shanahan, Samuel Roest, Stannard   +6 more
core   +1 more source

On the Influence of Antioxidants and Recycled MgO–C Source Material on the Mechanical Properties of Carbon‐Bonded Magnesia Refractories

Advanced Engineering Materials, EarlyView.
The presented study focuses on the fracture behaviour of carbon‐bonded magnesia MgO–C refractories, where environmentally friendly fructose, collagen and lignin serve as temporary binding agents. The partial substitution of the source material with recycled MgO–C reduces the fracture resistance, which can be counteracted by the additional introduction ...
Marc Neumann, Tom Weber, Jana Hubálková, Florian Kerber, Dinesh Kumar Gunasekar, Hans Jelitto, Christos G. Aneziris   +6 more
wiley   +1 more source

Four‐Point Bending Tests at High Temperatures on Commercial MgO‐C Refractory Bricks with and Without Recyclate Considering Different Carbon Contents

Advanced Engineering Materials, EarlyView.
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm, Lukas Knöchel, Thomas Schemmel, Christos G. Aneziris, Anja Weidner, Horst Biermann   +5 more
wiley   +1 more source

Effects of direct-contact ultrasonic vacuum drying on the drying characteristics and quality of dandelion [PDF]

Shandong kexue
This study investigated the effects of direct-contact ultrasonic vacuum drying on the drying characteristics and quality of dandelion. Dandelion samples were dried under different ultrasonic power levels and compared with samples processed via vacuum ...
CAI Yuanyuan, DONG Hongjing, SHAO Rencai, LIU Feng
doaj   +1 more source

Sol–Gel Derived Polymer Precursors for Stereolithography of ZrC

Advanced Engineering Materials, EarlyView.
ZrC is a critical material target for extreme temperature conditions. This report describes a protocol for preparing ZrC ceramics via stereolithography and examines the impact of the polymer matrix on carbothermal reduction and mechanical stability of 3D printed ZrC.
Charles J. Rafalko, Evelyn Wang, Michael A. Hickner   +2 more
wiley   +1 more source