Results 21 to 30 of about 31,424 (213)

Superlubricity and Corrosion Inhibition Properties of Solvate Ionic Liquids in Hybrid Carbon Fiber Reinforced Plastic–Steel Interfaces

open access: yesAdvanced Engineering Materials, EarlyView.
Solvate ionic liquids lubrication reduced the coefficient of friction by ∼60% compared to dry sliding, reaching steady‐state values as low as 0.04–0.05. Corrosion weight‐loss measurements in 1 M HCl further demonstrated significant inhibition behavior, with only 100 ppm of [Li(G3)][TFSI] (∼68.5 μL/L) reducing corrosion‐product weight loss by 63 ...
Sameh Dabees   +6 more
wiley   +1 more source

Biomass Native Structure Into Functional Carbon‐Based Catalysts for Fenton‐Like Reactions

open access: yesAdvanced Functional Materials, EarlyView.
This study indicates that eight biomasses with 2D flaky and 1D acicular structures influence surface O types, morphology, defects, N doping, sp2 C, and Co nanoparticles loading in three series of carbon, N‐doped carbon, and cobalt/graphitic carbon. This work identifies how these structural factors impact catalytic pathways, enhancing selective electron
Wenjie Tian   +7 more
wiley   +1 more source

Composites of Shellac and Silver Nanowires as Flexible, Biobased, and Corrosion‐Resistant Transparent Conductive Electrodes

open access: yesAdvanced Functional Materials, EarlyView.
Shellac, a centuries‐old natural resin, is reimagined as a green material for flexible electronics. When combined with silver nanowires, shellac films deliver transparency, conductivity, and stability against humidity. These results position shellac as a sustainable alternative to synthetic polymers for transparent conductors in next‐generation ...
Rahaf Nafez Hussein   +4 more
wiley   +1 more source

Molecular Adsorbing Host•Guest (MAHG) Crystals: A New Paradigm for Porous Materials?

open access: yesAdvanced Functional Materials, EarlyView.
Networking! Introduction of guest molecules in macrocycles before crystallization profoundly influences the material obtained in terms of structure and function. Beside simplicity and porous space improvement, this approach is endowed with a huge potential given the myriad of potential guest molecules that can be used to tune this burgeoning class of ...
Ingrid Suzana   +4 more
wiley   +1 more source

Counterion Dependent Side‐Chain Relaxation Stiffens a Chemically Doped Thienothiophene Copolymer

open access: yesAdvanced Functional Materials, EarlyView.
Oxidation of a thienothiophene copolymer, p(g3TT‐T2), via different doping strategies and dopant molecules resulted in materials with similar oxidation levels and a high electrical conductivity of ≈100 S cm−1. However, mechanical properties varied significantly, with sub‐glass transition temperatures and elastic moduli spanning from –44°C to –3°C and ...
Mariavittoria Craighero   +12 more
wiley   +1 more source

Self‐Sintering Ionogel Binder for Flexible, Recyclable, and Healable Printed Giant Magnetoresistive Sensors

open access: yesAdvanced Functional Materials, EarlyView.
ABSTRACT Electronic waste has emerged as a major environmental challenge, driven by the massive consumption and a limited lifetime of modern electronic devices, stimulating the development of sustainable electronics. Here, an all‐biomaterial gelatin‐choline‐citric acid ([Ch][CA]) ionogel is developed as an active binder to realize self‐sintered ...
Lin Guo   +10 more
wiley   +1 more source

Receptor‐Free Identification of Toxic Gases Enabled by Hygroscopic Aqueous Salt Films

open access: yesAdvanced Functional Materials, EarlyView.
Water as a gas sensor coating sounds impossible—until it stops evaporating. Here, hygroscopic salt solutions (LiCl, LiBr, H3PO4) form non‐drying aqueous films on CNT chemiresistors under ambient air. Gases partition into these liquid layers, sometimes transforming into water, and generate salt‐specific resistance fingerprints across a four‐channel ...
Seongwoo Lee   +5 more
wiley   +1 more source

Spin Injection Of Exciton–Polaritons With Halide Perovskites At Room Temperature

open access: yesAdvanced Functional Materials, EarlyView.
A monolithic Tamm‐plasmon microcavity embedding a two‐dimensional halide perovskite enables room‐temperature spin injection of exciton‐polaritons under quasi‐resonant optical excitation. Polarization‐resolved spectroscopy reveals partial preservation of the injected spin in the lower polariton branch, while bare excitons remain fully depolarized.
Elena Sendarrubias Arias‐Camisón   +8 more
wiley   +1 more source

Fully Additive Vertical Organic Electrochemical Transistors on Renewable and Compostable Substrates Enable Ultrasensitive Bioelectronics

open access: yesAdvanced Functional Materials, EarlyView.
Fully additive vertical organic electrochemical transistors (vOECTs) with channel‐length of 226 nm on a 50 µm compostable substrate achieve >106 current modulation and ∼36 mS transconductance. Ion‐selective integration enables 1.1 mA dec−1 sensitivity and 36 µm detection limit, highlighting a scalable platform for sustainable electronics and ...
Giulia Frusconi   +3 more
wiley   +1 more source

Intrinsic Photoactive Star ZnPc–Poly(glutamate) Nanoplatforms for Multimodal Glioblastoma Therapy and Brain‐Targeted Delivery

open access: yesAdvanced Functional Materials, EarlyView.
An intrinsic photoactive star‐shaped zinc phtalocyanine‐poly(L‐glutamic acid) (ZnPc‐PGA) nanoplatform for multimodal glioblastoma (GBM) therapy and brain‐targeted elivery. A ZnPc‐PGA‐based multifunctional theranostic nanocarrier platform enables image‐guided, multimodal GBM therapy. ZnPc‐PGA nanocarriers support the integration of fluorescence imaging,
Amina Benaicha‐Fernández   +14 more
wiley   +1 more source

Home - About - Disclaimer - Privacy