Results 221 to 230 of about 724,235 (283)

Technoeconomic Evaluation of Combined Rich and Lean Vapour Compression Configuration for CO2 Capture From a Cement Plant [PDF]

open access: yesInternational Journal of Greenhouse Gas Control, 2023
A combined rich and lean vapour compression configuration was investigated for CO2 capture from a cement plant. This was to assess its performance in energy consumption, actual CO2 emission reduction, and cost reduction potentials compared with the ...
Solomon Aforkoghene Aromada   +2 more
exaly   +2 more sources

Analysis of a Vapour Compression Refrigeration System via Exergetic Performance Coefficient Criterion

open access: yesJournal of the Energy Institute, 2011
A theoretical performance analysis based on exergetic performance coefficient (EPC) criterion was carried out for a vapour compression refrigeration system for different refrigerants.
Ali Volkan Akkaya
exaly   +2 more sources

Vapour-compression refrigeration systems

Applied Energy, 1990
Abstract Vapour-compression units are the most widely used refrigeration systems. Interactive computer routines have been composed, in BASIC language, in order to permit the prediction of the performances of simple, multi-evaporator multi-stage compressor vapour-compression refrigerators when employing refrigerant R-11, R-12, R-22 or R-502.
O. Badr, P.W. O'Callaghan, S.D. Probert
openaire   +1 more source

Mechanical vapour compression (MVC)

Journal of Heat Recovery Systems, 1984
Abstract Mechanical Vapour Compression (MVC) is an old technique which has shown a renewal of interest since the first fuel crisis some 10 yr ago. The intent of this paper is to make the reader more aware of the potential in terms of energy and cost saving.
H. Moser, J.-P. Denisart
openaire   +1 more source

Thermoeconomic optimisation of the condenser in a vapour compression heat pump

International Journal of Refrigeration, 2004
In the paper, the design optimisation of a heat exchanger is discussed, using a thermoeconomic approach. The investigation is referred to the tube-in-tube condenser of a conventional vapour-compression heat pump, with a two-phase refrigerant flowing in the inner tube and a single-phase fluid flowing in the annulus.
DENTICE D'ACCADIA, MASSIMO, Vanoli L.
openaire   +5 more sources

Compressible vapour flow in conduits and fractures

Journal of Fluid Mechanics, 2016
We consider the steady flow of a viscous compressible gas through an axisymmetric or two-dimensional porous medium whose properties in the direction of the flow are sufficiently slowly varying. The study is partly motivated by a number of different applications in the Earth sciences, including the release of magmatic volatiles from a magma chamber ...
Huppert, Herbert E, Sparks, R. Stephen
openaire   +3 more sources

Integration of absorption and vapour-compression systems

Applied Energy, 1993
Abstract This paper describes the integration of different types of absorption systems with vapour-compression systems. The performances of such systems have been analysed thermodynamically using various refrigerant/absorbent pairs. The first part of this paper is concerned with the intermittent absorption system, the intermittent absorption/vapour ...
S.B. Riffat, N. Shankland
openaire   +1 more source

Refrigerants for vapour compression refrigeration systems

Resonance, 2012
With the mandate of Montreal Protocol banning ozone depleting substances, and Kyoto Protocol later on curtailing the use of substances which contribute to global warming, conventional refrigerants are to be replaced by environment-friendly working fluids.
G. Venkatarathnam, S. Srinivasa Murthy
openaire   +1 more source

Home - About - Disclaimer - Privacy