Train Slide or Slip Compensation Study Based on Multiple Sensors
Velocity and distance measurement system based on pulse speed sensor and accelerometer was introduced. Process of train slide or slip was analyzed, and according to the change of acceleration and velocity, the slide or slip was divided into acceleration ...
ZHANG Jiangtao, LIU Ze
doaj
A linear hydraulic fracture with tortuosity and fluid–slip at the fluid–rock interface
A hydraulic fracture with tortuosity and fluid–slip at the fluid–rock interface is replaced by a two-dimensional symmetric model fracture. The mathematical model is formulated using a modified Reynolds flow law and a linear crack law.
M.R.R. Kgatle-Maseko, T.L. Vetezo
doaj +1 more source
Time-Resolved Studies of Stick-Slip Friction in Sheared Granular Layers
Sensitive and fast force measurements are performed on sheared granular layers undergoing stick-slip motion, along with simultaneous imaging. A full study has been done for spherical particles with a +-20% size distribution.
A. Bak +43 more
core +2 more sources
A Liouville theorem for the planer Navier-Stokes equations with the no-slip boundary condition and its application to a geometric regularity criterion [PDF]
We establish a Liouville type result for a backward global solution to the Navier-Stokes equations in the half plane with the no-slip boundary condition. No assumptions on spatial decay for the vorticity nor the velocity field are imposed.
Giga, Yoshikazu +2 more
core +2 more sources
Influence of Test Temperature and Test Frequency on Fatigue Life of Aluminum Alloy EN AW‐2618A
The influence of test temperature and test frequency on the fatigue life of EN AW‐2618A is investigated. High‐cycle fatigue tests are performed at different test temperatures and frequencies on the 1000 h/230°C overaged state. Both test parameters reduce fatigue life due to time‐dependent damage mechanisms.
Ying Han +5 more
wiley +1 more source
Analysis of Boundary Slip in a Flow with an Oscillating Wall
Molecular dynamic (MD) simulation is used to study slip at the fluid-solid boundary in an unsteady flow based on the Stokes second problem. An increase in slip is observed in comparison to the steady flow for shear rates below the critical shear rate of ...
Mohseni, Kamran +1 more
core +1 more source
Simulation of copper-water nanofluid in a microchannel in slip flow regime using the lattice Boltzmann method with heat flux boundary condition [PDF]
Laminar forced convection heat transfer of water–Cu nanofluids in a microchannel is studied using the double population Thermal Lattice Boltzmann method (TLBM). The entering flow is at a lower temperature compared to the microchannel walls.
D'Orazio, Annunziata +2 more
core +1 more source
Creep Properties and Deformation Mechanism of Additively Manufactured NiAl‐CrMo Composites
Additively manufactured NiAl‐CrMo composites contain numerous interfaces and cell boundaries that control their creep response. At 700°C under high applied stress, creep is dominated by dislocation‐controlled power‐law mechanisms. At 800°C–900°C and lower stresses, creep is primarily diffusion‐controlled along cell boundaries.
Jan Vollhüter +9 more
wiley +1 more source
Effect of stick-slip on magneto-rheological elastomer with a magnetic field
This study investigated the stick-slip characteristics of a magneto-rheological elastomer (MRE) against an aluminum plate. Herein, the MRE was manufactured, and a stick-slip tester was employed to evaluate the stick-slip performance of the MRE under ...
Chenglong Lian +3 more
doaj +1 more source
Velocity slip of liquid flow in nanochannels
Molecular dynamics simulations are carried out to investigate the velocity slip phenomenom of liquid flow in nanochannels. The liquid is argon, and the wall is taken to be platinum or its model solids. The effect of the surface wettability on the velocity slip is obtained through varying the potential interaction strength between the liquid and the ...
null Cao Bing-Yang +2 more
openaire +1 more source

