Results 101 to 110 of about 2,043,867 (313)
Advanced Engineering Materials, EarlyView.This perspective reframes additive manufacturing for electrical machines as a qualification‐limited materials and architecture design problem. It links process–structure–property–performance relationships to magnetic, conducting, dielectric, and thermal property windows, highlighting where AM can enable segmented magnetic circuits, permanent magnet ...
Dénes Fodor, Loránd Szabó
wiley +1 more source
In autopsy practice, the thickness of ventricular walls is one of the parameters used to identify cardiac hypertrophy. The presented study aimed to compare ante- and postmortem measurements of ventricular wall thickness, (i) to determine a postmortem ...
Tse, R +5 more
core +1 more source
Effect of variable wall thickness on wall stress distributions.
, 2014 (A) Axisymmetric model with longitudinally-varying wall thickness. (B) Plane strain model with circumferentially-varying wall thickness. In all cases, an internal pressure of 0.016 N/mm2 (120 mmHg) was applied.
Phong T. Dargon (595172) +4 more
core +1 more source
FastNano Liquid: An Automated Platform for Small‐Angle X‐ray Scattering‐Based Materials Discovery
Advanced Engineering Materials, EarlyView.We present FastNano Liquid, an automated small‐ and wide‐angle X‐ray scattering platform for the combined synthesis and characterization of (nano)materials. The platform is coupled to varied reactor workflows for both in situ studies of reaction kinetics and ex situ screening of synthesis conditions to support machine learning‐guided exploration ...
Pierre‐Baptiste Flandrin +16 more
wiley +1 more source
TomographyBackground/Objectives: Left ventricular (LV) geometry reflects structural adaptation to aging and biological sex. While cardiac magnetic resonance (CMR) provides precise morphologic assessment, most prior studies have focused on volumetric and mass-based
Davut Unsal Capkan, Mehmet Kaplan
doaj +1 more source
Analysis of Material Deformation and Wrinkling Failure in Conventional Metal Spinning Process [PDF]
, 2012 Sheet metal spinning is one of the metal forming processes, where a flat metal blank is rotated at a high speed and formed into an axisymmetric part by a roller which gradually forces the blank onto a mandrel, bearing the final shape of the spun part ...
WANG, LIN
core
Advanced Engineering Materials, EarlyView.This study proposes a potential device design for joint cartilage replacement. Silica‐polytetrahydrofuran (SiO2‐PolyTHF) hybrids with customizable mechanical properties were developed to mimic the characteristics of a natural meniscus. These were synthesized through a two‐pot sol–gel hybrid process.
Yu‐Chien Lin +12 more
wiley +1 more source
Phenyllactic acid (PLA) exhibits antibacterial activity against Listeria monocytogenes which is a significant foodborne pathogen. In this study, effects of PLA on the cell survival, cell morphology, cell wall thickness, extraction of cell wall ...
Bi, Mingli +7 more
core +1 more source
Lumen diameter and wall thickness analysis.
, 2016 Histomorphometric comparison of the inner diameter (A) and wall thickness (B) between the nanofiber PCL/CS TEVGs and the native CA revealed no significant difference in the inner diameter and a significant difference in the wall thickness.
Cameron A. Best (3145380) +12 more
core +1 more source
Wall Thickness Measurement of Pipes by Using Digital Radiography [PDF]
, 2015 One of the most important parameters in a pipeline to be monitored and measured is the wall thickness. Pipe wall thickness can vary after a certain period of time, as a result of accumulation of various chemical or physical effects.
N. Altinsoy +3 more
core +1 more source