Results 281 to 290 of about 6,710,712 (351)
Some of the next articles are maybe not open access.

The Excellent Water Lubrication Additives for Silicon Nitride to Achieve Superlubricity under Extreme Conditions.

Langmuir, 2019
Superlubricity has been recognized as the future of tribology. However, it is hard to achieve superlubricity under extreme conditions such as a high load and low sliding speed on the macroscale.
B. Lin   +5 more
semanticscholar   +1 more source

Seal Lubrication of an Automotive Water Pump

Tribology, 2006
A noisy mechanical seal is a grave problem, especially in water pumps designed for the automotive industry. The noisiness is often caused by dynamic instability (stick-slip behavior), which occurs when the seal lubrication changes from hydrodynamic to mixed.
ANTONINI, Massimo   +3 more
openaire   +2 more sources

Water-Lubricated Soft-Rubber Bearings

Journal of Fluids Engineering, 1932
Abstract Rubber bearings lubricated with water are found to have remarkably low coefficients of friction and to give excellent service under many conditions. The softness of the rubber makes these bearings stand up in the presence of sand and grit, and it also makes the laws of lubrication governing these bearings differ from the ...
W. F. Busse, W. H. Denton
openaire   +1 more source

Synergistic water lubrication effect of self-assembled nanofilm and graphene oxide additive

Applications of Surface Science, 2018
In this study, a pretreatment method was proposed to enhance the lubrication effect of GO as additives. During pretreatment, 3-aminopropyltriethoxysilane (3-APS) nanofilm was successfully fabricated on substrate surface by self-assembled technique. The 3-
Xing Li   +4 more
semanticscholar   +1 more source

Lubrication Characteristics of Water-Lubricated Rubber Bearings With Partial Wear

Journal of Fluids Engineering, 2019
Abstract Water-lubricated rubber bearings are widely used in the propulsion shafting of military craft and ships. These bearings may wear down after a period of service, and consequently, their lubrication characteristics will change, affecting the operation of the shaft.
Gang Liu, Ming Li
openaire   +1 more source

Water-Based Lubrication of Hard Carbon Microspheres as Lubricating Additives

Tribology Letters, 2018
Because of their superior physical and chemical stability, carbon microspheres have been identified as promising lubricating additives. In this paper, hard carbon microspheres with diameters ranging from approximately 130 to 250 nm were prepared through a hydrothermal method using glucose as the carbon source.
Ying Wang   +5 more
openaire   +1 more source

A Review of the Design and Feasibility of Intelligent Water-Lubrication Bearings

Journal of Marine Science and Application, 2022
Enchi Xue   +3 more
semanticscholar   +1 more source

The Elastohydrodynamic Lubrication Analysis of Starved Water-Lubricated Rubber Bearing

Applied Mechanics and Materials, 2012
Water becomes a good application prospect lubricant for its low cost, energy saving, good safety and environment friendly characteristic. A bearing microscopic surface pitting lubrication model was established, the water condition of it was introduced and the effects of the speed and the load on the film thickness were discussed.The result show that ...
Hui Zhao, You Qiang Wang
openaire   +1 more source

Effect of Water Temperature on Tribological Performance of B4C-SiC Ceramics under Water Lubrication

Tribology letter, 2021
Wei Zhang   +4 more
semanticscholar   +1 more source

Lubrication Theory and Viscous Shallow-Water Equations

2018
In this proceeding dedicated to Enrique Fernandez-Cara, we indicate how to derive rigorously lubrication equations studied in [A.L. Bertozzi, M.C. Pugh, CPAM (1998)] from the viscous shallow-water equations with drag terms and surface tension effect in the one-dimensional in space case.
Colin, Mathieu   +3 more
openaire   +2 more sources

Home - About - Disclaimer - Privacy