Fatigue &Fracture of Engineering Materials &Structures, Volume 49, Issue 7, Page 2929-2944, July 2026.ABSTRACT The fatigue and fracture behavior of self‐piercing rivet (SPR) joints between AA6016 aluminum sheets (1–2 mm) and DX54D steel (0.95 mm) was studied under 90°, 45°, and 0° multiaxial loading. Pure shear (90°) loading produced the highest fatigue strength, whereas multiaxial (45°) loading resulted in reduced performance, with pure tension (0 ...
Alan Woo +5 more
wiley +1 more source
Effect of Sandblasting Pressure Combined with Acid Pickling on the Microstructure and Surface Properties of Ti-6Al-4V Alloy. [PDF]
Materials (Basel)Xie Y, Li L.
europepmc +1 more source
Greenhouse Gas Reduction Potential Through Bioheat for Remote Communities in Northeastern Ontario
GCB Bioenergy, Volume 18, Issue 7, July 2026.Heating infrastructure in remote areas has high potential for fuel switching, possibly leading to decreased greenhouse gas emissions. Using a simplified life cycle analysis approach, we show that woody residues from the forest industry have the potential to reduce greenhouse gas emissions compared to commonly used fossil fuels.
Sabrina M. Desjardins +6 more
wiley +1 more source
Synergistically Reinforced Copper-Free Friction Materials with Agricultural Wastes and Carbon Fibers: Evaluation of Tribological Performance. [PDF]
Materials (Basel)Tian Y, Huang K, Xu Z, Zhuansun Y, Ma Y.
europepmc +1 more source
Marine Mammal Science, Volume 42, Issue 3, July 2026.ABSTRACT Microplastics have been identified in hundreds of species, with evidence of trophic transfer via contaminated prey. Sarasota Bay common bottlenose dolphins (Tursiops truncatus) serve as sentinels of coastal pollution, including plastics and chemical plasticizers. Previous research confirmed microplastic ingestion in these dolphins (100.0%, n =
Estella Martin +12 more
wiley +1 more source
Microstructure and Friction-Wear Properties of 1Cr13 Coating on SAE 1045 Prepared by Arc Cladding. [PDF]
Materials (Basel)Chen M, Chen J, Zhu Y, Li X.
europepmc +1 more source
3D‐Printed Sulfur‐Derived Polymers With Controlled Architectures for Lithium‐Sulfur Batteries
Advanced Functional Materials, Volume 36, Issue 44, 1 June 2026.Rheology‐guided formulation design for direct ink writing enables the fabrication of 3D sulfur copolymer cathodes with controlled architectures for lithium‐sulfur batteries. The printed electrodes exhibit multiscale porosity and high sulfur utilization, delivering enhanced electrochemical performance compared to conventional cast electrodes.
Bin Ling +7 more
wiley +1 more source
Advanced Functional Materials, Volume 36, Issue 46, 8 June 2026.A MXene/PEDOT coating enables multimodal functionality and dual‐analyte detection of dopamine and serotonin in flexible microelectrode arrays while enhancing electrophysiological recording quality. The anti‐fouling, low‐impedance interface overcomes key limitations of conventional coatings, providing a robust and versatile platform to investigate the ...
Ilaria Gatti +8 more
wiley +1 more source
Tribological Failure in Modern Total Hip Arthroplasty: A Narrative Review of Third-Body Wear, Oxidative Degradation, and Cross-Linked Polyethylene Longevity. [PDF]
CureusPowell SN +7 more
europepmc +1 more source
Systemic Cobalt Toxicity Secondary to Tibial Component Malpositioning in Bilateral Primary Total Knee Arthroplasties. [PDF]
Arthroplast TodayVallabhaneni N +5 more
europepmc +1 more source