Results 131 to 140 of about 867,348 (311)
Effect of atmosphere and temperature on wear, friction, and transfer of polyimide films [PDF]
Friction and wear experiments conducted on polyimide films bonded to 440C stainless steel disks indicated that a wear transition (from high wear to low wear) accompanied the friction transition (from high friction to low friction).
Fusaro, R. L.
core +1 more source
Experimental Analysis of the Wear Properties of Carburized HSS (ASTM A600) Cutting Tool [PDF]
, 2017 Prediction and control of undesirable deterioration of cutting tools are the most essential challenges emanating in the design of tool which has to be checked.
Abioye, Abiodun A. +7 more
core +2 more sources
Mechanotransducing Organic Electrochemical Diode for Crosstalk‐Inhibited Artificial Skin
Advanced Functional Materials, EarlyView.An innovative approach is presented to a stretchable mechanotransducing diode that unifies rectification and tactile‐sensing functionality. This approach enables to fabricate the diode that maintains a large rectification ratio (5 × 102) at a high operational frequency (100 Hz).
Taeyeong Kim +7 more
wiley +1 more source
Friction and wear of iron in sulfuric acid [PDF]
Elemental iron sliding on aluminum oxide in aerated sulfuric acid concentrations ranging from very dilute (0.000007 N; i.e., 4 ppm) to very concentrated (96 percent acid) was studied. Load and reciprocating sliding speeds were kept constant.
Buckley, D. H. +2 more
core +1 more source
Advanced Functional Materials, EarlyView.Enzymatically crosslinked gelatin‐based organohydrogels, fabricated through a fully bio‐based and scalable process, exhibit exceptional strain and temperature sensing capabilities with minimal interference from environmental humidity. These transparent, stretchable, and ionically conductive materials operate without synthetic fillers or dopants.
Pietro Tordi +7 more
wiley +1 more source
Advanced Functional Materials, EarlyView.A vertically stacked, DEA‐driven photonic array inspired by cephalopod skin, featuring highly crystalline colloidal crystal gels with vivid color, low FWHM and scalability is presented. The multilayer design removes lateral pixel interference, achieving near‐100% fill factor with fully independent RGB actuation.
Maga Kim +11 more
wiley +1 more source
NanomaterialsThis study highlights the impact of low amounts of MoS2 quantities on composite performance by examining the effects of ultrasonication exfoliated MoS2 at different loadings (0.1–0.5 wt%) on the mechanical and tribological parameters of epoxy composites.
Ravisrini Jayasinghe +3 more
doaj +1 more source
Study of abrasive wear rate of silicon using n-alcohols [PDF]
The work carried out at the University of Illinois at Chicago for the Flat-Plate Solar Array Project under contract No. 956053 is summarized. The abrasion wear rate of silicon in a number of fluid environments and the parameters that influence the ...
Danyluk, S.
core +1 more source
Motor brush wear measured with strain gages [PDF]
, 1970 Balanced bridge circuit, supplied with low-voltage direct current and connected to a readout device, measures remaining brush material, rate of brush wear, armature runout, and brush ...
Farrell, W. T., Peek, C. R.
core +1 more source
Selection Strategies for Flexible Pressure Sensor Electrode Materials Toward Ultrafast Response
Advanced Functional Materials, EarlyView.This study reveals, for the first time, how the electrode–organic interface governs the temporal performance of flexible pressure sensors. By pairing high‐conductivity CVD PEDOT with commonly used metal electrodes, the authors demonstrate that interfacial energy alignment dictates microsecond‐scale response, providing a straightforward design strategy ...
Jinwook Baek +11 more
wiley +1 more source