Results 121 to 130 of about 3,927,971 (264)
MICROSTRUCTURE AND WEAR RESISTANCE OF A COMPOSITE Gr/Al2O3/Al PRODUCED BY RECIPROCATING EXTRUSION [PDF]
, 2012 Zhihao Zhang +3 more
openalex +1 more source
Cutting tool wear monitoring with the use of impedance layers [PDF]
, 2014 The article deals with problems of cutting process monitoring in real time. It is focused on tool wear by means of impedance layers applied on ceramic cutting inserts.
Kratochvíl, Jiří +5 more
core
Effect of adding SiC on resistance wear and hardness through stir casting of aluminum matrix composites [PDF]
, 2019 Nur Wahyuni +3 more
openalex +1 more source
WEAR RESISTANCE OF ARC SPRAYED COATINGS TYPE OF Fe-C-Cr-Ti-Al AFTER PLASMA REMELTING
, 2016 Им Первого +9 more
openalex +1 more source
Plasma deposition and surface modification techniques for wear resistance [PDF]
The ion-assisted or plasma coating technology is discussed as it applies to the deposition of hard, wear resistant refractory compound films. Of the many sputtering and ion plating modes and configurations the reactive magnetron sputtering and the ...
Spalvins, T.
core +1 more source
Tribological behaviour of the low and high viscosity peek against steel using different contact pressures [PDF]
, 2013 In the market of polymers for tribological applications polyetheretherketone (PEEK) are often used for satisfying requests coming from industry regarding enhanced properties such as, thermal stability, friction and wear resistance.
Andó, Mátyás +4 more
core
A study on wear rates of 100Cr6 steel running against sintered steel surfaces under dry and starved lubrication [PDF]
, 2008 This paper investigates the tribological behavior of 100Cr6 steel pin running against sintered steel bearing material used in hermetic compressors. Tests were conducted under dry and starved lubrication sliding conditions in air at room temperature ...
Aksit, Mahmut Faruk +8 more
core
Механика машин, механизмов и материалов, 2010 Dependences for calculating assessment of resistance of wear-fatigue damages (wear intensity, mechano-sliding fatigue limit, wear life) for an active system "piston ring - cylinder liner" of explosion engine are suggested (the back effect).
A.V. Bogdanovich
doaj