Results 141 to 150 of about 1,781,818 (285)
Materials and Corrosion, EarlyView.Climate‐neutral green hydrogen is produced via water electrolysis using renewable energy. This study explores using cold gas spraying to apply titanium coatings on steel bipolar plates for proton exchange membrane water electrolyzers. The coating shows effective corrosion protection, presenting a promising solution for future designs.
Kirsten Bobzin +3 more
wiley +1 more source
Hydrogen Analyses of FSW Cu‐OFP Tested Under Creep Conditions in Sulphide Containing Environment
Materials and Corrosion, EarlyView.Friction stir welded Cu‐OFP exhibits elevated creep rates in sulphide‐containing aqueous environments, with creep increasing as sulphide concentration rises. Hydrogen measurements indicate that sulphide exposure does not increase hydrogen content. ABSTRACT Friction stir welded oxygen‐free phosphorus‐doped copper (FSW Cu‐OFP) is a candidate material for
Patrik Sahiluoma +3 more
wiley +1 more source
Materials and Corrosion, EarlyView.The corrosion rates of two types of magnesium alloys in an alkaline solution containing crushed ordinary Portland cement paste grains decreased with increasing immersion time. This decrease was attributed to the formation of a protective layer containing brucite and hydrotalcite on the specimen surfaces.
Kazutoshi Fujiwara +5 more
wiley +1 more source
Chemically and Mechanically Recyclable Polyolefins Incorporating Covalent Adaptable Networks
Macromolecular Rapid Communications, EarlyView.Low‐molecular‐weight polypropylene is converted into a crosslinked polyolefin containing a covalently adaptable network. The semicrystalline material remains melt‐processable and mechanically recyclable. Its thermal and mechanical properties are comparable to commercial polyolefins.
Andrii Tiiara +4 more
wiley +1 more source
MetalMat, EarlyView.Overlap percentage governs the remelting, dilution, and solidification behavior of CMT‐WAAM AISI 308L stainless steel. Increasing overlap to 50% promotes stronger bead‐to‐bead bonding, wider transition zones, and localized hardness enhancement, with the highest hardness observed in the overlap region due to grain refinement and δ‐ferrite redistribution.
Mojtaba Karamimoghadam +4 more
wiley +1 more source
Radiometric Constraints on the Timing, Tempo, and Effects of Large Igneous Province Emplacement
Geophysical Monograph Series, Page 27-82., 2021 Exploring the links between Large Igneous Provinces and dramatic environmental impact
An emerging consensus suggests that Large Igneous Provinces (LIPs) and Silicic LIPs (SLIPs) are a significant driver of dramatic global environmental and biological changes, including mass extinctions.
Jennifer Kasbohm +2 more
wiley +2 more sources
Improved many-objective particle swarm optimization based welding sequence optimization research. [PDF]
PLoS OneDong L, Gu S, Dong J, Ji Q, Liu J.
europepmc +1 more source
Polymer Engineering &Science, EarlyView.Adhesively bonded ASA/PA12 FFF sandwich structures reveal that interfacial compliance governs mechanical performance. Cyanoacrylate enhances strength but induces brittle failure, while polyurethane improves ductility and impact resistance, demonstrating that adhesive properties and stacking sequence are critical design parameters for optimizing multi ...
Berkay Ergene +3 more
wiley +1 more source
Polymer Engineering &Science, EarlyView.Numerical simulation of polyethylene rotational molding using the Smoothed Particle Hydrodynamics (SPH) method. ABSTRACT This work presents the development of a numerical model based on the smoothed particle hydrodynamics (SPH) method to simulate the rotational molding process of powder thermoplastic polymers, used in the manufacture of liners for high‐
Ali Nourreddine +4 more
wiley +1 more source
Polymer International, EarlyView.An overview and categorization of man‐made per‐ or polyfluoroalkyl substances (PFASs) including low‐molar‐mass and high‐molar‐mass fluorochemicals, and their international regulations is presented. Though certain PFASs are toxic, bioaccumulative and cross the human cellular membranes, others, such as fluoropolymers, are safe, reliable and involved in ...
Bruno Améduri
wiley +1 more source