Results 51 to 60 of about 18,306 (307)
THE PROCESSING OF HYPERBOLOID SURFACES USING WIRE ELECTRICAL DISCHARGE MACHINING – PRACTICAL ASPECTS
Nonconventional Technologies Review, 2018 The paper presents practical aspects of an original method that can be used for cutting hyperboloid surfaces using wire electrical discharge machining (WEDM). The processing method, which has only been partly revealed by the author in certain relatively
Calin Denes
doaj
Modelling and experimental investigation of process parameters in WEDM of WC-5.3 % Co using response surface methodology [PDF]
, 2012 Tungsten carbide-cobalt (WC-Co) composite is a difficult-to-machine material owing to its excellent strength and hardness at elevated temperature. Wire electrical discharge machining (WEDM) is a best alternative for machining of WC-Co composite into ...
K. Jangra, S. Grover
core +1 more source
Smart Catheters for Diagnosis, Monitoring, and Therapy
Advanced Healthcare Materials, EarlyView.This study presents a comprehensive review of smart catheters, an emerging class of medical devices that integrate embedded sensors, robotics, and communication systems, offering increased functionality and complexity to enable real‐time health monitoring, diagnostics, and treatment. Abstract This review explores smart catheters as an emerging class of
Azra Yaprak Tarman +12 more
wiley +1 more source
Electrical Discharge Machining for Glass with Wire Electrode
Journal of The Japan Society of Electrical Machining Engineers, 1974 This paper describes fundamental experiment on the electrical discharge machining with wire electrode. A thick glass plate could be ground and cut by the electric arcs generated along the contact line between the glass plate and the wire electrode in an electrolyte.
Tadahiko WATANABE +3 more
openaire +2 more sources
Advanced Healthcare Materials, EarlyView.Implantable optoelectrical devices are an effective resource for the modulation and monitoring of neural activity with high spatiotemporal resolution. This review discusses current challenges faced by these devices and outlines future perspectives for the development of next‐generation neural interfaces targeting chronic, multisite, and multimodal ...
Stella Aslanoglou +4 more
wiley +1 more source
Nonconventional Technologies Review, 2018 The paper presents an original method that can be used for cutting hyperboloid surfaces using wire electrical discharge machining (WEDM). The processing method, which has only been partly revealed by the author in certain relatively low-impact Romanian ...
Calin Denes
doaj
Guidelines to select suitable parameters for contour method stress measurements [PDF]
, 2020 The contour method is one of the promising techniques for the measurement of residual stresses in engineering components. In this method, the cut surfaces deform, owing to the relaxation of residual stresses.
Naveed, Nida
core +1 more source
Advanced Materials, EarlyView.This review provides an overview of triboelectric nanogenerator (TENG)–based biomedical applications by classifying studies into electronic and ionic systems across attachable and implantable platforms. It summarizes key material choices, device structures, and working mechanisms that characterize current TENG‐based research, and outlines six future ...
Kyongtae Choi +12 more
wiley +1 more source
Parametric Optimization of Wire Electrical Discharge Machining in AA7075 Metal Matrix Composite
Advances in Materials Science and Engineering, 2022 Aluminium 7075 metal matrix composite reinforced with silicon nitride was fabricated using the stir casting technique. Composite fabricated was machined and subjected to wire electrical discharge machining to study the significant process parameter ...
K. Raju +4 more
doaj +1 more source
An electrode wire for use in wire electrical discharge machining
, 2016 MY Patent App.
Maher, Ibrahem +2 more
openaire +1 more source