Patches in a side-by-side configuration: a description of the flow and deposition fields [PDF]
, 2014 In the last few decades, a lot of research attention has been paid to flow-vegetation interactions. Starting with the description of the flow field around uniform macrophyte stands, research has evolved more recently to the description of flow fields ...
Bouma T.J. +9 more
core +1 more source
Bearing Capacity of L-shaped Latticed Joints Connected by Welding of Screw-fitted Dowels
BioResources, 2022 Three kinds of L-shaped latticed joint were designed to study the shear bearing capacity of joints prepared by welding of wooden dowels prepared with self-tapping screws.
Xudong Zhu +9 more
doaj +2 more sources
Seismic reliability assessment of classical columns subjected to near-fault ground motions [PDF]
, 2013 A methodology for the performance-based seismic risk assessment of classical columns is presented. Despite their apparent instability, classical columns are, in general, earthquake resistant, as proven from the fact that many classical monuments have ...
Fragiadakis, Michalis +2 more
core +5 more sources
Validation study for Large-Eddy Simulation of Forest Flow [PDF]
E3S Web of Conferences, 2020 The publication presents Large-Eddy Simulation (LES) of flow over a reduced-scale wind tunnel model of a forest canopy. The final aim of the study is to determine factors responsible for damage in forests by strong winds.
Pitchurov George +3 more
doaj +1 more source
Performance Accuracy of Hand-on-needle versus Hand-on-syringe Technique for Ultrasound-guided Regional Anesthesia Simulation for Emergency Medicine Residents [PDF]
, 2014 Introduction: Ultrasound-guided nerve blocks (UGNB) are increasingly used in emergency care. The hand-on-syringe (HS) needle technique is ideally suited to the emergency department setting because it allows a single operator to perform the block without ...
Herring, Andrew +3 more
core +3 more sources
Erratum to: Numerical damage prediction in dowel connections of wooden structures [PDF]
Materials and Structures, 2015 My;Rk 1⁄4 0:3 fu;k d where My;Rk is the fastener yield moment, fu;k is the characteristic tensile strength, and d is the bolt diameter. Because of this error, one result is wrong in Table 4 (see below), from where the authors claimed that the analytical procedure of EC 5 [1] leads to an 82.7 % underestimation of the connection strength with respect to ...
M. Khelifa +3 more
openaire +1 more source
International Journal for Computational Civil and Structural EngineeringThis study presents an experimental investigation into the thermomechanical behavior of wood structures assembled with densified wooden dowels under fire exposure.
T. T. Tran TRAN +3 more
doaj +1 more source
International Journal for Computational Civil and Structural Engineering, 2018 A comparative analysis based on a series of numerical simulation experiments in the ANSYS software for determining the bearing capacity and the optimal arrangement of CFRP dowel pins in the joints of wooden structures.
Mikhail A. Vodiannikov
doaj +1 more source
Lateral holding strength of wooden dowel, screw and ready-to-assemble joints (RTA joints) constructed of Medium Density Fiberboard (MDF) [PDF]
تحقیقات علوم چوب و کاغذ ایران, 2009 In the present study the strength of different kinds of wooden dowels, screws, and ready-to-assemble joints (RTA joints) used in medium density fiberboards (MDF) were assessed and compared for their lateral shear strength. The T-form specimens (20 cm × 8
mohammad ghofrani, Habib Nori
doaj +1 more source
Reinforcement of Joints Between LVL Members with GFRP and Finite Element Analysis
Drvna Industrija, 2022 The goal of this study was to investigate the effect of glass fiber reinforced polymer (GFRP) on joints made of laminated veneer lumber (LVL), through experimental data and evaluation by ANSYS finite element (FE) software.
Mosayeb Dalvand +2 more
doaj +1 more source